Search results for query: *

under multi media in control panel,make sure all of you playback and recording devices are there.Click on the device tab, then double click on the speaker icon, right click on the drop down menu.Then click on properties. This will tell you the status of you playback device. Enabled or Disabled...

Are you sure that the disc is being CLOSED(Finalized)??? In your advanced settings you have options such as DAO(Disc at once) TAO(track at once)etc. There are sub options under tha TAO setting giving you the option of closing or not closing the CD or the session. If one of the options for NOT...

Try going from Start>Programs>Accessories>Communications> Phone Dialer. Click on Phone Dialer,Click on the tools menu, Then click on dialing properties. Fill in what country your in, type in your area code.Then click on the AREA CODE RULES button. Check the box that says 10 didgit dialing. Click...

Try a communication test between you printer and computer from your printer toolbox under programs. If this does'nt work try a new cable. Sometimes they just go bad.

Go to System Information under System Tools and click on Modem.

Had the same problem on a computer. Like you I was questoning the Mother Board. Swapped out the processer and bingo!! It was working again. But it COULD be the M.B. so don't rule that out yet. But try swapping the processor first. Or it could be a RAM problem also. What type of BEEP CODES are...

I'm assuming that you're not getting any power at all, or just for a breef second if any. If that's the case, I'd say that you're shorting out against the case. Try loosening all of the screws and try rebooting agin.If that does it, install some NYLON STANDS. That should take care of it.

I had a similer problem with a DVD Play.It worked fine one day. The next time I went to use it,I had the same problem as you. Open up the your case and make sure that the power connector, and your IDE cable both have "A GOOD CONNECTION"!!! Unplug them both, than reseat them to make...