Search results for query: *

It was never networked, just used sets to program, so the ip is unchanged. I dont remember about dn length though. If it were different would that stop it...?? ob is quite a distance away so can't get there when i want.. Mike

Will take a few days but no problem Mike

I'm not entirely sure of the software in the CP, but it did work before the move, and like I said it works on the 3x8 I use as a tester/spare. I changed the power supply the the 2 corded one (new) with no difference. I've been going over this in my head for days and the only thing I can think of...

I just moved a CICS 6.0 and callpilot 100 to a new location. I sat for about 3 months before reinstall. The Call pilot won't sync up ( no green connect light). I have used a serial cable and watched the install on a 3x8dr5 and i DO get a sync. So now I'm leaning towards a bad KSU. A bit more...

Took a bit of fiddling to make it work but I got it. The instructions missed the part about CONF switching from line 1,2,3 etc. Just thought I'd note it for the next guy searching the same thing. Again Thanks Mike

I believe its just an IPK, thats all it says on the case.

Is this in the Electra Elite IPK Programming Manual or in a different one. Thanks

My customer aquired this Elite from somewhere. It has the old config including VM. I'd like to disable the vm, perhaps on 2 incoming lines, but could also default the system. Could someone point me in the correct direction please. Thanks Mike

sorry.....4.0 software...duhh!!!

I suspect it is a mismatch. The CICS is 6.0 I am unsure of the VM but it is older. I will get an older CICS software to match it up. Thanks

I recently aquired a NAM 2. I installed it on a CICS with 2 digit DN and the VM was set at 3. The NAM boots fine, makes all the bells and whistles but none of the features except F915 work. All it does is revert to date and time in the display. Any ideas or suggestions would be appreciated. Mike

I will only use the ATA2 if the sub wants internet access OR if the want an analog set with all lines ringing to it.

If you are just now purchasing the system the sets usually come with extra clear green and grey buttons. Ask the vendor before you go out and buy more.

Lots of fun. I use a set of dollar store headphones and cut the ear part off. Be careful stripping the ends and check that the fine wires inside aren't coated with a thin layer of plastic. A BIC lighter will clear it off.

Thanks for the help guys I got it to work. I made an answer DN on an old set at the equipment and had it ring across the paging system, Then programmed all sets in the plant to pickup for that ringing. Unfortuneatly it works at all times but that really wasn't a problem. As a matter of fact now...

8x24 DR5 w/ flash4

I just had this same problem. Spent hours on it. Called my tech support and he had me use Feature **xftest and test and delete any keys that were active. Rebooted and 5 minutes later worked like a charm. Good luck.

I have flash calling ext XXX at night. It is an emergency set. I know I can have external ringers but I want to have multiple extensions ring and be able to pick up those internal calls. Any suggestions would be appreciated.