Search results for query: *

I have a new version of Call Pilot installed on a CICS system. In a CCR tree, I am using Park & Page to the external paging option but it does not work. The calls park, but no page. Park & Page works correctly on the internal page. The Page feature to the external paging works correctly from...

I have a similar setup working. A hunt group will overflow to another hunt group on 6.1, so you may want to look at that closer. I also have an old ATA on the switch board that is included in the primary huntgroup so that I can have greater control over what happens when the real sets are all...

The ATA ext# is included in the hunt group (just a work around); it is programmed to fire off the Aux Ringer any time a call hits that extension. This solution causes excessive queuing if all the "valid" extensions are busy.

Correct, the HG key is assigned to the sets. The HG works on the sets fine. Its the ringer that refuses to fire when the HG rings.

Yes. The target line/hunt group appear on the set (as opposed to being on the intercom key)

The hunt group is being fed by a target line from a PRI. I also assume that this is a 6.1 bug in that they are specifically letting you option for the aux ringer as part of the hunt group configuration; no sets should be required to make this happen. Any work around (i.e. ATA programmed to aux...

On a MICS 6.1, hunt group 708 is programmed to have the aux ringer ring, but it refuses to do so. The ringer itself works fine when a particular set is programmed for the aux ringer, so wiring, etc is good. Anyone have any ideas? Chuck Silva Techni-Link

Check your d-channel in LD17 to make sure it is set for USR (not NET) and external clock (EXT) if the Adtran is passing the C/O's clock to the switch. The Adtran should be set for network timing as well as the DSX port on the Adtran. This can cause clock slippage until the maintenance...