Search results for query: *

fonedude, No red LED. Top yellow is lit when on a voice channel (standard). Thanks, mj4321

fonedude, it says "connecting" mj4321

Chcoale, I did set protocol w19 ppp, and both netmasks, dip swiches set, broadcast high. @ show w19 Active Configuration: all the addresses look right, but the Interface:(says)Unassigned (PPP) is this right? fonedude, yes The provider says the signal is 64K clear channel PPP. mj4321

I have connected to the module with HT and programmed the router as/per the magix install instructions. I’m using channels 20 – 23 for data (256k). The rest of the channels are for the phone system using PRI. I went right down page 6-46 on “steps required to configure the INA”, programming...

Thank-you Ghostin and jinxs. The t/r to CO works. I now need to decide which one to go with. The input from you both has been very helpful and I do appreciate it. Thanks again, mj

Ghostin, Will that explains it. Not really what I wanted to hear. I was trying exactly what you said. In an attempt to save system resources (ext. ports) on the main system, I was trying to use a co-lo system to run T/R lines used only for Fire, Elevator, Fax, and Modem applications. With...

I am trying to co-locate 2 Magix systems using 4 CO lines between them. I put the lines in pools, assigned Tandem sw. IDs, programmed UDP and ARS, and inabled remote calling, but when I dial a non-local ext. there is no response, just silence in the handset of the calling ext. When I do a Tie...

I got it. The system was in KEY mode. As soon as I changed it to Hyb/PBX mode it programmed as it should. Thanks!

Trying to program the 100DS1 617N15 module on the Legend system. I have done the Magix system with no problem. In this case all programming went fine until I got to the PRI > B-channel grp > IncomingRtg. When I try to press the IncomingRtg soft key (in order to set "Dial Plan"), the...