Search results for query: *

I have setup multiple IPSEC tunnels between the PIX and 1711 router successfully, and am now trying to access the multiple LAN segments using the CISCO CPN client through the PIX. I can successfully make the client connection and can ping the network directly connected to the PIX's internal...

More info needed: Type and version of IOS? Does it have a firewall feature set? and what version? running-config or show tech support minus password and public ip addresses as well as any company info. Does the problem occur only from some machines or all?

If you have not already done so, move a known good and working router to the switch and test again. If that resolves the problem try reconfiguring or replacing the router. If the test yields the same result, try connecting the original router to a known good switch. If that resolves the problem...

I have not seen any hard and fast rule, but if 3des is needed, you'll need a 1700 or greater router.

KSE and Nakona, Thank both of you for your responses. Nakona--the router is set for 100 full and the nodes are a mix. KSE, I will try removing proxy-arp, thanks.

That is the correct DG. As mentioned in the message, the configuration is ultimately NATted twice. "The configuration I'll post shows both networks being private. This is how the router is configured. The 192 addresses are then translated through a DSL modem to public addresses. This was...

PROBLEM: When I apply an inbound extended access list I retain connectivity for up to 10 minutes, but then loose the ability to connect, and smtp traffic also slows then stops. NAT is in use. ip inspect is in use Only 3 ports are required to be open inbound 25, 80, 110 (also have 5800 and 5900...

PROBLEM: When I apply an inbound extended access list I retain connectivity for up to 10 minutes, but then loose the ability to connect, and smtp traffic also slows then stops. NAT is in use. ip inspect is in use Only 3 ports are required to be open inbound 25, 80, 110 A little background. The...

To follow on svermill's note, when a file is copied directly to running-config, some commands will replace original commands, and others will cause a merge to occur. For example, int s0/0 ip address x.x.x.x x.x.x.x will change the IP address of serial interface 0/0 Wheras, access-list 101...

You can obtain them from Cisco's web site. Here is a sample URL produced by going to Cisco's web site and searching for configuring Firewall Feature Set...

You can obtain them from Cisco's web site. Here is a sample URL produced by going to Cisco's web site and searching for configuring Firewall Feature Set...

Has anyone broken the code to calculating time worked within a specified timeframe (ie 7am-7pm) excluding weekends and holidays? I have seen a number of referneces to calculating days worked, but I need to get it down to hours and minutes worked within that timeframe excluding weekends and...