Search results for query: *

One reason can Hot Line - try SUDIP,SPEXP. Next step is signal trace (on DIR or ELP6). Is dialling possible after busy tone?

What about try EXTEI:DIR=6847,..... Probably it won't helps but better try everything before restart.

This units are not responsible for this problem. Only handlers. Try: HIREI EXDDP,(KSDDP),(SUDIP) HIMDP In my very private opinion it can be problem in Number Analysis.

I'm not really sure, but this feature is since BC11.

Which system?

I'm not sure but on the first look problem is in TSW. After first RECSIG (D3)with number 2 TSW sent SENSIG (D2) with number 5 - Send calling party category. PE answer 1 - Subscriber without priority. Then TSW should send 5 again - send A Number Identification. But TSW sent 1 - send next called...

I have the same experience. No RTP resources are used in the originating exchange, 2 resources are used in the terminating exchange. I have made trace on signalling and it looks like the calling phone got only IP address of IPLU in term.exch. and never got IP from answering phone. Maybe I did...

Alarm 271 means, that opposite equipment can't see your transmit. Transmit FROM this eq. to MD is OK. Use LED for test of your transmit.

RODDI:ADC=05051.....

And what about HIMDP? Any ENTNOPSTA signal here? It can be problem with analog extension.

What about restart of THH?

First time test Dial from A to B on digital telephone. Remember number on display B. Then dial from B to A exactly the same number. Next - call back fails - when init. request (phone A press 6) or - when executing (phone B hang up)? For both direction Of course rodap,roddp,cadap

Board TLU76/3 = K sig = TLP30 Programming ISDN,Qsig = SLP60

try aerjot.pl

Use admin mode (C*5) before loggoff.

Which type of flash?

Try 1. VARC D4 = F 2. Be sure that TLU and recorded message system are connected to the same groud.

I think this file should be load zipped.

IMHO MASTER LIM is this LIM, which is receiving external synchronization. One of PCM line form this LIM is marked as MCCL and this is clock source for GS. We have some exchanges with external clock in LIM 3,4,6, and works fine.

Before moving ext.sync. to LIM 1, try to complete internal sync. SCICI:MCCL=x-x-xx-x, RCCL=, ACCL= (SMCCL,SRCCL,SACCL) I dont't know reason why ext.sync. shoult be in LIM 1.