Search results for query: *

We have purchased the VM-ETH-INTERFACE FAL104535 license. I think the IP link between MD110 and OneBox server is working properly because I have tested with OneBox configuration tools ( Control Panel/ OneBox/ Switch ... )and I have no alarm in MD110. My new problem is that I can't transfer...

I want to configure OneBox 3.0 for a MD110 BC12SP4. There is a document from OneBox that shows the programming steps: 1. Programming NIU port for Voice Mail. 2. Initiating the Information Computer Function. 3. Initiating the Voice Mail Function. After the VMFUI command, when I tried to...

<ROCAP:ROU=10; ROUTE CATEGORY DATA ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP 1 011000000000001 4 0001000001 0 30 128 00151515 011101000050 001100 END <RODAP:ROU=10; ROUTE DATA ROU TYPE VARC VARI VARO FILTER 1 TL30...

I don't have remote/mobile extension! I'm afraid the problem is around the TLU76/3 or TMU revision ( PROM-SET ). I upgraded the system from BC9 and before I didn't had that problem. The parameters for the route are the same.

I have a problem with the channels in an E1 CAS R2 link with PSTN. They are remaining one by one in NOPROGRESS / BUSY status until the communication is blocked. The channels are not connected ( I checked with LSCOP command ) but when I try to acces the route the message &quot;Congestion&quot; is...

Hi, I need a SCSI adaptor for HDU7/2 board. I want to make one myself but I dont't know how. Is enybody that can give me an advice? Thanks.

I have a problem with Ethernet connection to the NIU board.I set up the IP address 192.168.1.101, mask 255.255.255.0 to the NIU board and in the niux commands the response to the ping 192.168.1.101 is &quot;Machine is alive&quot;. I have tested the cable between my computer and another one. It's...