Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

OneBox MD110 integration 3

Status
Not open for further replies.

coslo

Technical User
Feb 20, 2003
7
RO
I want to configure OneBox 3.0 for a MD110 BC12SP4. There is a document from OneBox that shows the programming steps:
1. Programming NIU port for Voice Mail.
2. Initiating the Information Computer Function.
3. Initiating the Voice Mail Function.
After the VMFUI command, when I tried to initiate a voice-mail port: VMPOI:IFCIND=1,DIR=3001&&3004,PORT=001; the message "No license available" has appeared.
Do I need special licenses for analog extensions declaring these extension as voice-mail extension type?
 
you need license's

do a LIDAP and it will show you what licenses you have already, and how many you have used out of your avialable licences
 
You need lcence:
VM-ETH-INTERFACE FAL104535 if VM is connected to NIU via Ethernet
Or
VM-V24-INTERFACE FAL104534 if VM is connected to NIU using serial link (RS232)
 
Do I need special licenses for analog extensions declaring these extension as voice-mail extension type? "
[red]No,you don't.[/red]
But you need a license for [red]Voice Mail port.[/red]

Experience it, there is no substitute.
 
We have purchased the VM-ETH-INTERFACE FAL104535 license.
I think the IP link between MD110 and OneBox server is working properly because I have tested with OneBox configuration tools ( Control Panel/ OneBox/ Switch ... )and I have no alarm in MD110.
My new problem is that I can't transfer calls even if I set Blind Transfer, Confirmed Transfer or Transfer in Call Processor settings. If I call the directory number of hunting group, the message is playing ( I used the default message from Day Call Processor: 000 ) and after I have dialled the number of desired extension I'm receving disconnect tone and the specific extension is ringing one time.
I thought that the problem was because of Recognition time for clear ( Parnum=252) and Recognition time for Hookflash ( Parnum=253 ). I have set in OneBox and MD110 recognition time for flash 500ms and recognition time for clear 1000ms but the problem is the same.
Please advice me with this issue.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top