The bugs added by SP3 are partially listed here. It includes the spooler issue mentioned by tahoe2.
http://support.microsoft.com/default.aspx?scid=/support/servicepacks/windows/2000/post-sp3_hotfixes.asp
Also, I would use the TFTP server and a "wr net <tftp-ip>:filename" to save a binary of the config. Copy and paste "wr t" to notepad and save to a text file should also be done.
As far as the VPN, there is a wizard on PDM that is pretty cool and will configure it properly...
Hmmm,
first, remove these lines. Mixing conduits and access-list is a not supported configuration.
access-list dmz permit ip any any
access-group dmz in interface dmz
access-group dmz in interface outside
Remove
static (inside,dmz) bbb.bbb.bbb.0 bbb.bbb.bbb.0 netmask 255.255.255.255 0 0
You...
Hi Malderse,
You have enough flash just to go to 5.1 and you won't gain much from where you are. IMHO, the effort to upgrade is only worthy if you go straight up to 6.2(2). Need to upgrade the flash.
There will be a lot of translation work. Some commands in 4.4 have a different syntax than...
Hi malderse,
start by checking how much memory you have by using SHO VER. There is a conversion table to help you:
i28F020 512 KB
AT29C040A 2 MB
atmel 2 MB
i28F640J5 8 MB - PIX 506 16 MB - all other PIXes
strata 16 MB
these are the minimum requirements per version:
PIX Software version...
Also, the recommended VPN client version for use with the PIX is 3.x. The old secure vpn client version 1.x is compatible, but not recommended.
For windows is 3.6.3, for MAC/Linux is 3.7.
good luck,
jacare
A good way to start is to install a log capture service (i.e http://www.kiwisyslog.com/index.htm), change the logging level in the PIX to at least 4 (warnings) and start looking for weird messages.
Some people put the Exchange server in the DMZ and some let it on the inside. I like the later. Just install an IIS server in the DMZ with SMTP properly configured (check MS KB articles 257426, 314961 and 293800) to relay mail to the internet and leave the Exchange server inside. Only need a...
Thanks for the tips folks. I added the interface for PAT as suggested by "themut" and it started working. I finally realized that the ARP cache of the router that the outside interface that it is connected to (63.137.81.153) was dirty and it had 63.137.81.154 associated with another...
This is very weird, CISCO could not figure it out yet.
I am using PIX 6.2(2) and PDM 2.1(1).
1-VPN from outside to inside works fine
2-Traffic between DMZ and outside works fine
PROBLEM: Can't get out to the internet from inside interface.
For what I've read, this is all that is required to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.