Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
HSRP in one router
E1 E2 | | | | |----------| | Router | HSRP |----------| | | E3 Yes you can,it will also enable you to load balance across the your interfaces(inf). You must have like for like protocols running on these inf's and these inf's must have interdomain routing(just... -
frame relay
Your question is rather vague grasshopper, but you must remember you are in a Cisco chat window. Do not labor yourself with such matters if you are not in a large frame relay environment. Your Cisco router is more than you will need. Obewan -
Can't ping own Interface
There is a simple solution to this problem but first let me try to better understand your question.When you say your interface are you trying to ping the interface on the same router you are in session with? if not follow this procedure exactly: 1)setup up your circuit on your serial int... -
No interfaces show up to be configured when I try to set up a 2600.
the problem lies in your config registers. power reset your router so that that it starts to go through a setup but prevent it from going through by pressing ALT-B which is a break, then type at rmon prompt: confreg 0x2102 then press I then reload when your router starts it will go through setup... -
Secondary interface
You could definitly setup an ACL and group on the 192.68.0.0 network to deny any 212.12.12.0 network traffic e.g.Broadcast or ICMP. I will send you a sample config. access-list 101 deny tcp 172.16.4.0 0.0.0.255 any eq access-list 101 permit ip any any (implicit deny any) (access-list 101...
