indywright
MIS
We had a power outage and we thought we lost the flash on our router because when it would start up an error messge would come up stating that the flash could not be located.
We tried to reinstall the flash several times with no luck. We then reseated the flash and now when the router boots up it will go to the setup program however no interfaces show up to be configured. It is a 2600 with two ethernet interfaces and even when I type in any "show" command (run, start, or interface) that should show the interfaces they do not show up.
We tried to reinstall the flash several times with no luck. We then reseated the flash and now when the router boots up it will go to the setup program however no interfaces show up to be configured. It is a 2600 with two ethernet interfaces and even when I type in any "show" command (run, start, or interface) that should show the interfaces they do not show up.