Search results for query: *

Hello. I have managed to get our 5610 IP phones connected over VPN by way of our Cisco ASA. We have IP office 500 and the few VPN-enabled 5610's we have had in use for a few years seem to have been doing fine until we added ~10 more 5610's. Now, all the phones are getting "bumped" off VPN...

I am hoping someone can help me on this. Apologies for merely being dangerous with DNS. I have two DNS servers running on Server 2008 Standard and they have resolved names just fine until recently. We now find that subdomains, e.g., reports.servername, will not resolve unless from XP or Windows...

That's correct, I am using redirect (F84). I am not doing a F4 to an external # since this is not allowed on my 4.0 system. I have allowed redirection for all of the sets and the call actually does redirect to external numbers with F84. It just cuts off when routing to a DID that terminates on...

I have a MICS 4.0 and am trying to redirect sets to external DID's which reside on another exact system in another office. However, the call rings once to the assigned external set and then disconnects (which is OK if the person sitting there is quick to pick up). I have tried doing the same to...

Thanks. Yeah, I ended up putting the new circuit in loopback until the DID's are ported from the current one. Looks like a hot cutover is my only choice.

I currently have a T1 from provider ABC and have a PRI from provider XYZ which is ready to be turned up on my MICS 4.0. ABC's T1 is the primary clock source. However, XYZ says they MUST provide line timing on their PRI, there is no other way to provision. I called ABC and their tech told me the...

I have a MICS 5.0 and have programmed 3 CCR trees. Under F983, I assigned the appropriate tables for the lines and they did work. Line 242 (target DID line), for example, was assigned to table 2. This was working earlier in the day when I first tested it. Now I am getting all three of my CCR...

I need to bring down more than the last 100 emails in the Exchange inbox to the Treo (Treo defaults to the previous 100 emails on first synch with a new device). I once called a customer support line, Goodlink I think, and the tech had me go into some funky programming mode that allowed me to...

Does anyone know where I can find reviews of network providers? Even a forum discussing those merits? You would think this would be an easy task but I have found so many worthless sites. Currently, I am at odds between going with current Bigtelco's MPLS point-to-point network and saving a huge...

This happened to us. The vmail boxes were breached from the outside. The ones that were breached had easy passwd - 1234. The violator accessed the admin functions of the mailbox and set up calls to transfer to the international operator. The mboxes were initally setup so that the outdial was set...

Can one enable wireless synching remotely? Either from BES or via registry key or sys file? We just upgraded to a new Exchange BES from an older Notes BES. Unfortunately, I discovered how to setup this new function (new to us) only after reinstalling nearly half the desktop managers. I thought I...

Norstar vmail 3.0 software running on a MICs 4.1

Hello. I am trying to assign a DID to an Information mailbox and, well, it's not working. My ultimate objective: I need callers routed through a DID to an information greeting. I have several toll-free numbers to eliminate from heavy use and my plan is to redirect them to a DID that greets...