Search results for query: *

That is one of those new 5G antennas.

The link above is for a 2 line device. If they only have a one line device, why can't you get one for each line?

Check out Viking Products. They have some devcies used to prevent a fax/modem from going off hook and interrupting a call in progress. They should work for what you need. https://www.vikingproductstore.com/Viking-TG-2-2-Line-Teleguard-Privacy-Device.html

The batteries are used to keep the speed dial, auto dial and or caller ID numbers in the event the phone is unplugged from the line (-48vdc removed) The batteries are not required to make or receive calls. I suspect this is a problem with the hook-switch/plunger. Try manually pulling it up when...

bad memory chip. set the diag level to max, then the power-on self test will show the bad memory.

I'm not aware of any way to do this in Aspect. There is no scroll bar or slide bar in the dialog box controls.

Hangup should work, but you will need to wait a few seconds for the connection to clear. Also, I usually logout of the remote host, then issue a hangup command.

You need to have the service bit enable to get to the disk replacement menu, that is step 1-a in the instructions. However, I think you can also get to that menu if you connect to the modem port or if you have a modem connected, just dial into that and see if you can access the menu. If you...

No, just follow the directions in the manual, Repair and Replacement chapter, replace system drive in multiple drive server section. You will not have to do any of those other steps.

I'm guessing you don't have a service manual. You can get it here. http://downloads.avaya.com/css/P8/documents/100007420 The steps in general. 1. Shut down the system 2. Insert a new drive in an empty slot. For you this is probably slot 5. 3. Boot the system into the disk utilities menu. 4...

Hello, I'm not sure that your plink command will still work after the telnet is disabled on the remote server. Because with this part "-L 9091:198.249.28.129:23" you are setting up port 9091 at IP 198.249.28.129 to forward to port 23 on the same server. Essentially, you are telling the...

Hello, I just reviewed the steps and compared them to my notes and they seem correct. However, it has been a couple of years since I installed Cygwin and configured it to use telnet. It is possible that the Cygwin packages may have changed, or some of the prompts may be different. I did...

This is a feature, I think it is called Access Security. It is enabled in the Class of Service. However once it is turned on, you can't turn it off in the COS. But, the user can control it from their personal options menu.

Your waitfor commands are not seeing what you are waiting for. For example, "waitfor "type" is not seeing the word "type." Therefore, it times out after 30 seconds, the default then goes to the next line.

check aspectscripting.com There is a script samples page that has a few sample scripts that sort items.

This is what I use and it works for me. set dialentry access telnet "Host1" ;set the dial entry connect telnet "Host1" ;connect

Yes, it is possible. It has been a while since I've done this, but I believe all you have to do is plug the new power supply in. There is no feature bit or software configuration.

Can you post a sample of your data file?

Good discussion topic. Being an old phone guy, who now works mostly on the data side, my observation is that data people, in general, lack basic trouble shooting skills. Which, I beleive is because of their training. When I started in telecom, we had a trouble shoouting class. We were taught...

Is that mailbox being used on menu 4 as a port monitoring mailbox?