hi,
how do i associate the system name or the eth interface to the ip address i have assigened to the interface.
Im right at the beguining trying to set up the licence and i am already stuck on this.
I have a nokia 330p brand new with checkpoint 41 preinstalled.
This is what i get...
hi morph,
I see you have stablish the inside and outside interfaces for NAT but i can't see where are you doing the actual translations---------> you need to setup a pool of addresses to use or some static translations.
Have a look at that...
bye,
milikk
Hello cbum,
-YES, i'm using the same u/p, for the router and the fritz, that's why i assume that the problem is not on the tacacs+ config.
The problem is that separately, either the fritz card and the access router are working just as expected, but for some reason they don't like each other...
Hello Danny,
It will be helpfull if you have a look at the routing on the firewall, maybe you will need to add a route there back to network b.
What i don't understand is why if you are routing directly to A's default gateway from the 1601 you have to pass across the 2620 (looking at the...
Hello cbum,
Thank you for helping me with this...
-Yes, the 800 uses both channels and the same line that the fritz is using, that's why i'm sure the line is ok.
-Yes, the fritz card can connect to the 3640 using just one channel.
-I tested the config of the card with a different...
Ok, this is my problem:
When dialing into the access-router(Cisco 3640, Version 12.0(7)T,) from a remote pc using an isdn fritz card it only uses one of the to available B channels.
We use tacacs+ and i have included the "maximum links 2" on the entry for the user.
I have tested the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.