Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Phaser 340 Fault 06,001.42:77473
The X-Axis HOME positioning is not working properly. The error code description indicates that the sensor has failed, or something has interferred with its motion. If youcan remove the case and ink loader, you should see if anything (including the power harness) is keeping the printhead from...- Rhooker
- Post #2
- Forum: Printers general discussion
-
Phaser 340 - print head fault? but prints different jet lines
You msut first check the Cap/Wipe/Purge assembly to make sure it is working properly. This is the unit that rises between the drum and printhead when you first start the printer up. If the rubber seal is broken on this unit you will simply load the head up with ink and jam all the jets. If the...- Rhooker
- Post #2
- Forum: Printers general discussion
-
Tektronix phaser 350
The fault code reads: "Failure positioning drum maintainence cam during a drum maintainence cycle; check the drum maintainence cam solenoid, clutch, home sensor, and related hardware." My experience is that the "white clutch" has failed, as they often do. This term is used...- Rhooker
- Post #2
- Forum: Printers general discussion
-
Ouch! non standard inks...
The error code you note relates to the Cap/Wipe/Purge assembly motor and locating sensor. The PRECISE message code reads in part "An expected transition of the cap home sensor did not occur.". This mechanical failure has no relation to the ink used in the printhead. There is no...- Rhooker
- Post #3
- Forum: Printers general discussion
