I would suggest running scanner(just read the tape don't rebuild index) on a tape to verify there are no synchronization errors. My tapes were reporting a similar High GD amount and found out the tape unit was rewinding in the middle of backups and networker reported everything worked fine.
This is known as the sticky bit. Do a man page on chmod.
The numeric number after chmod can be a 4 digit #.
chmod 1000 file-name will set the sticky bit on....
We also have a HP 9000 running 11.0. I have noticed the same situation on our machine. The machine was up for 7 months and the memory had reached 98% and paging was 60.
After a boot for security patches, with similar workloads as before, memory utilization is 65% and paging 17%. After running...
I have an 11.0 HP-UX system and ignite was not installed. I downloaded and installed from above site. The make_recovery tape is very important. We use ifconfig to define multiple IPs to one machine. This can be defined in /etc/rc.config.d/netconf to mantain after a boot. You can change an IP's...
Wayne,
Most HP systems have c0t1d0 as the primary boot and c0t2d0 as secondary and mirrored. Did you truely replace one of these drives. I should have found out more before I responded. Don't do the above commands until you are sure you lost a mirrored copy of your boot volume. If you lost...
Wayne,
If you replaced the drive and still able to boot, I assume you booted off a mirrored copy of your boot volume. If you are running on the mirrored copy then you shouldn't have a problem restoring. First do the command:
vgdisplay -v vg00
Any disk problems? Any stale extents?
You can...
Read man pages on mc command.
mc -p /dev/rac/c10t3d0 -sS1 -dD1
This command will load a tape from storage location 1 and load in tape drive1. These commands are relative to 1 and my
ATL is relative to zero. May also read man pages for mt command.
I suspect I have an internal configuration problem with my Quantum ATL P2000. I have hp-ux 11.0 connected to a silkworm 2400 brocade switch. The P2000 has two fibre connections to the brocade switch and a total of 4 tape drives. Two tape drives are assigned to each fibre channel.
Drivers are all...
I suspect I have an internal configuration problem with my Quantum ATL P2000. I have hp-ux 11.0 connected to a silkworm 2400 brocade switch. The P2000 has two fibre connections to the brocade switch and a total of 4 tape drives. Two tape drives are assigned to each fibre channel.
Drivers are all...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.