Search results for query: *

you can order 2 PRI in a 46 + 2 configuration. The PRI's have the same circuit number but have a Sys 1 or Sys 2 added to the end. If adding a second PRI, order it using the original circuit number with the config above.

I've notice this on All releases. From what I've seem this is normal as all T7316 default out with a M7310 button layout.

With your current versoin of software no. The only MICS that had 2 digit Ext was the R1T1 or R1 anything after that had a minium of 3 digits.

Depends on how long the system wil be down for. If it going to be less that 24hours you should be fine with turning on Auto set relocation. Otherewise take a backup to be on the safe side.

Try going to the 7100 first if that is the mail box you want to end up in. Norstar Voicemail uses the first DN sdo the ATA's ext.

This seems to be an intermitant problem. Could it be a port issue? Or would the problem be on the flash card?

I have a VS mail 4.1. Recently we upgraded to 4X40 from 2X10 with the flash card. All ports were tested at installation but now we get an intermittant problem where messages are garbled. Its seems only to happen on about 1/2 of the Ext. Any idea's as to what is happening?

Your Feature codes are allready assigned. You likly had a power failure or something. To correct this enter: Feature **XFTEST Password = CONFIG In here you can test and release Feature Codes being held by the system and not in use.

I have a Merlin Magic and the DSS light are not working. The Recp. can tranfer using the DSS button but can not se who is on the phone. Is there a fix for this?

Ext 25 allready has a voice mail.. Therefore wherever you point the caller after it has been tranfered to Ext 25 it will go to Mailbox 25. Simple fix - delete mailbox 25

Check to see if in the CCR tree the path points directly to leave a message. That all I can think of.

Right,a but you still want the system to return dail tone, and you will be sending DTMF signals to the 8x24. Because of that you will need the E&M/DTMF card/s.

Do you have E&M / DTMF line cards intalled? I believe you need them to set up DISA on an 8X24

Try putting in a new LS/DS card, not sure what the Global Card. Also how is the circuit delivered to you? Is it an OPX? If it is have a look at that circuit, it might be in trouble or pair reversed. Let me know if this helps.

Could be that the LS/DS cards your using are an older type and are not transferable between systems.

I believe it is. Check to see if the Star Talk has more than 1 greeting table, that would be where you would set it up

Check the Lucent analog port to see is it has testing turned on. That more that likely is the problem

If your voice mail has a second langage set up, you can select the alt greeting when recording a message. In the time of day greeting you would say somthing like: Thank you for calling ABC company, for service in (laungage ) press 9 The in path 0 record both Primary(english)and secondary or...

Enter F885 and that will display the V-mail DN

Thanks