Search results for query: *

try pulling the Board unscrew the fixing screws pull out with both hands by the fixing screws just until it moves freely (no need to take it right out of the gateway) wait for upto a minute the push pack into place and you should see the boards lights go through a test cycle then go out. once...

If your NTP is dishing out time to it then changing the time on the time server should update the base but you might have to leave it a while to see the correction filter to handsets. If memory serves there was a time date issue with IP Dect. this might be what your running into but i think that...

Like the other guys said get a guy in and make sure they are have CM 7 install experience. Even experienced CM engineers can struggle with CM7 if they haven't been trained trust me i know.

If that lot doesn't work try using the console RJ45 to 9 pin serial lead. i would never recommend doing an NVram INIT to a box without having one. Serial connection is 9600 8, none 1 use putty set for serial.

Can i assume you have have removed and reseated the board ? as it is an analogue board it should be unaffected by IP changes.

Hi I have an issue that is starting to Vex me. To picture the scene, we have 2 H.323 trunks 30 channels each. each is supplied from a geographically different location over different infrastructure to a single far end CM and are identical in setup I do not have visibility on the third party CM...