Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. davetoenailsadams

    Hi all, I am new to this forum, be

    Still having same problem all. Today I tried reprogramming from a defaulted DB, as I had not mentioned this was set up on a backup Db. The Original system is running on 3.5 software, I have on my test system an upgraded to 3.8Bf MPB. The backup DB was initialised from 3.5.to 3.8. As mentioned I...
  2. davetoenailsadams

    Hi all, I am new to this forum, be

    Hi NFC, At this time all ports are opened to IP of VOIBE card. Via DMZ on router. Dave
  3. davetoenailsadams

    Hi all, I am new to this forum, be

    Sorry Eats, thought I had already replied to this. To confirm, I have opened/forwarded ports 1719,1720 TCP/UDP, 5060 UDP, & 2048-4096 UDP to the Lan IP of the VOIBE card, I have also set the DMZ to hit the same IP as well. When tracing with Wireshark I can see inbound RTP from Gamma going to...
  4. davetoenailsadams

    Hi all, I am new to this forum, be

    I think you are right NFC, not something in my comfort/knowledge zone, I have installed SIP on the later iteration of the system iPECS LIK & UCP. These use UDP ports 7000-10000, dependant on what gateways are used. I have to assume some internal magic occurs, as my SIP provider confirmed they...
  5. davetoenailsadams

    IPECS UCP-100 SIP Trunks and UCS Softphone App

    Another thought, are you using a VOIM gateway if so you will need to enter that sequence number instead. Dave
  6. davetoenailsadams

    IPECS50a

    Hi Eat4treats, Have you set the SIP lines to DID, and set the use modify digits table (PRG 145,I think) to PRG 231. Effectively treat the SIP lines as you would ISDN. Dave
  7. davetoenailsadams

    IPECS UCP-100 SIP Trunks and UCS Softphone App

    The on board VOIU for UCP's is sequence 2401, so basically go to program 132 (Board Based Attributes) enter sequence 2401 then check/add the Firewall(WAN ip). Also check DNS settings, but in my experience it should not be required unless you are using names instead of IP addresses, but will do...
  8. davetoenailsadams

    Hi all, I am new to this forum, be

    Many thanks for your input 2311angel. Apart from the codec settings on this page, I do not think there are a settings that can cause the problem I am experiencing. I have confirmed the codec G711 a-law with the SIP provider.
  9. davetoenailsadams

    Mfim 50b does not boot after upgrade failure

    You are right eat4treats. You can try contacting Pragma in UK. www.wearepragma.co.uk.
  10. davetoenailsadams

    Hi all, I am new to this forum, be

    Hi all, I am new to this forum, bear with me. I am trying to enable SIP trunks to an existing iPLDK300 Office 3.8 software. I am testing this on an in house setup so have complete control over the router ect. As this is now a legacy system in UK I am struggling to get dealer support hence my...

Part and Inventory Search

Back
Top