Search results for query: *

hi I configured CUCM and UCCX for auto attendant when I tried to call the trigger number from internal phone, it works and i can hear the auto attendant. But when I when i call from PSTN to the trigger number, it fails to connect and says "Unknown Number". But I can call to other extensions...

Hi, I am working on a class project for voip. I have got everything setup and working. HQ is configured with MGCP gateway and Branch is configured with SIP trunk.One of the requirement is that to "place two active calls between HQ and Branch and have the third call be rejected". Where should...

try 001B331A2439

It works! Assigned all the phones the same user/network music on hold source. disabled multicast routing in WAN interfaces. MOH streams from branch router in branch office!

I placed the MOH file on the remote gateway. But it only works when the system goes to SRST mode. Other wise I get the same issue as before when the WAN is up. This is what I have configured in the remote router call-manager-fallback max-conferences 8 gain -6 transfer-system full-consult ip...

I was able to figure it out. I Forgot to assign the port to pots dial peer. Now its working fine. Thanks

Hi, I configured SIP trunk in my Branch router. When I do show isdn status, it shows "Multiple frame estabhlished". But i am not able to make any calls out to PSTN and also cannot receive any calls from PSTN and HQ phones. HQ is configured with MGCP.

The b-channel is up. The mgcp gateway and SIP trunk are registered with call manager. I can only make calls to PSTN. I cannot make full DID number calls between the sites or within sites though. What debugs command should I use to check the status of my gateway?

It never worked. DID and DN match. I didnt translate them

When I make a call from HQ IP phones to PSTN, It works. But when I make call from PSTN to IP phone, it gives the busy tone. Its the same issue with Branch. Calls from branch to PSTN works but from PSTN to branch IP phones does not work. In HQ, MGCP gateway is configured and In branch, SIP trunk...

Thanks

Hi, I am using CUCM 8.6. I am trying to configure SIP trunk in Branch location. For destination address, what address should I put? Is it the Branch router address or PSTN/WAN router address or CUCM server address? Thanks

Unfortunately, my project requires to use two audio sources and I can only stream one audio source through the router. I created a new region with G.711 for moh everywhere. Assigned the region to the MoH device pool and device pool to the MOH server. enabled multicast routing in HQ, Branch and...

@whykap, This might be a dumb question but what is cco.?

I am using g711ulaw within sites in HQ and Branch and G729 between sites

There's no ACL blocking the MOH source. Max hop is configured as 3. I have HQ router, WAN/PSTN router and Branch router All the phones are registered to Sub. How do you configure Branch router to allow muticast MoH?

Hi everyone, I am working on a voip class project. There's a HQ and a Branch. The CUCM cluster is in HQ and consists of a publisher and a subscriber. I configured the multicast MoH for HQ and Branch phones. But the MoH is not working in Branch phones. When I make a call from "A" HQ phone...