Search results for query: *

Thank you, Kwbmitel I found the plug on the back side of the controller, so if I understood you well, I can actually just insert the wires to the controller plug without this "8 pins" mini din male connector?

ok so i guess my only solution is making my own E2T cable, will try that and let you know Many thanks

Just tried the "arptabShow" you mentioned above, it only shows the ip address of my computer and the one of the RTC itselfe.

Thanks for you replies I will try what you have mentioned, just another question, i am thinking of making a homemade E2T cable, do i still need to know the current E2T IP address when connecting via Cable ?? Thank you

I have the MAC Adress of E2T, but the IP Address does not show in either the ip configuration form or on the DHCP lease viewer. My problem is that the E2T card was assigned to an ip address that i dont know and i need to reset the E2T so that i can assign new IP Adress to it. The Controller is...

Hi all, I am having a hard time here, I digged up an old LX controller from my stock and i need to change its E2T IP address to match the range i will be using on my network. I dont know the old IP address of the E2T,i dont have a ps2 cable to connect to the E2T. I tried a telnet session on...

i found out that there is two problems, one stated by danramirez thank you for your help. and the other one is concerning the COR as i ve assigned a COR for the trunk attribute in the AX that doesnot allow out going calls through the E1 thank you both danramirez and bobcheese for your support

Thanks for your advice a question poping before i go to the site to check what u adviced me..... so i ve to assign another xnet trunk group for the E1 rather than the one used for ip to ip communication what about the voice medium am going to use is it ip-tdm or tdm-isdn am pretty confused...

Hi, i am having a problem here in which i cannot access the E1 trunk from my AX controller i have three controllers connected via IP/XNET all running MCD 4.2 2 MXE controllers (1 master and one resillient) 1 AX controller i configured the E1 trunk on the master MXE, phones are working good...