Search results for query: *

You could setup your ADSL in bridge mode and NAT the Fa0/1 interface and not the serial 0/3/0 interface. Then setup a default static route like VinceWhirlwind was saying and have all routers update via routing protocol or static routes.

Are you using a router for inter-vlan routing or is there any inter-vlan routing? I see you said your desktop was 10.111.x.x and you can ping the switch which is at 10.1.10.1 on vlan 119. Also i dont think you have to have a port dedicated to the switch, such as fa0/23 for vlan119(you stated...

Maybe you could set the static default to an exit interface instead of the dhcp ip. ip route o.o.o.o o.o.o.o fa0/0 also go ahead and hard code the fast ethernet interface to duplex half instead of negotiate just as a safey safe? I know it negotiated fine

Used to nat on my 2610, works good. I have a question about that though. The DSL modem is using NAT as well right? So is the 2610 natting my lan traffic and then the DSL modem natting my 2610 traffic?

Here is my setup: 2Wire 1000Sw: IP 172.16.0.1 255.255.255.0 Connected to Cisco 2610: Ip address eth1/0 172.16.0.254 255.255.255.0 eth0/0 192.168.1.1 255.255.255.0 connected to linksys wifi WAN 192.168.1.2 255.255.255.0 LAN 192.168.0.1 255.255.255.0 I have the static...

Hey i am kinda new to networking as well. I am guessing you will need basic security on it such as password protection probably SSH if you want remote configuration and if you do not want remote admin from the internet probably disable on that interface. Disable CDP. I do not much about ACL...

You could also run the "router# auto secure" secure command to help lock down the router. If you do not want to download the SDM.