Search results for query: *

You need to install Call Record using the Application software with 9.0.

I had the same problem. Good fix.

thread1553-1689348 I have corrupt software on a Callpilot Mini 1.6. Does any one have a copy of the software?

There is a patch for this.

Do you have enough of VCM on the IP Office?

Sounds more like the curse of the Avaya and what it did to the Nortel Systems.

I had the same problem on the same release, but in standard mode. My fix was made changing the Gains to -2.0db Gains: These settings are used to adjust the perceived volume on all calls. · A -> D: Default = 0dB Sets the analog to digital gain applied to the signal received from the trunk by...

Can anyone provide me with the Winspm software?

Make sure to sync the Master Radio under Advance TAb

Is there a license needed to upgrade to 5.0 or is it free? Does any one know what would be the upgrade steps to 5.0.

Select General, then Provisioning, Uncheck the Enable option, then Press Ok Go to DECT, Set Subscription to Disable from the drop down Menu, Set the Frequency to North American, then Press OK Now go back to General, then Provisioning, check the Enable option, then Press Ok Select Reset, Reset...

Setup a User Short code to Send Caller ID

Can anyone assist. I like to know is it possable to delete a mailbox on the IPO with Embedded VoiceMail. I know I can change the name field to create a new mailbox for a new employee. But what happens to all the old Mailbox? Do they just accumulate on the SD Card waiting to fill up the 15 Hours...

It is Rel 4.0 and was installed about 18 months ago.

I have had Two BCM that had Lost All Telephony Program on a hard reboot anybody have any ideas why?

RPM Database corruption sounds like. View Nortels KB.

You are correct there is no backup. In the past I have replace Hard drive on the BCM and have noticed if the core version on the hard drive is lower than the version on the MSC card I will loose Telephony. I have not tried applying the latest patches to a the New Hard Drive and then replace it...

Will I lose Telephony program on the MSC if I replacing a hard drive on a BCM that was patch up to date with a FRU that has no patches.

Make sure the payload size is the same for the trunks and IP sets.

Try to connect an ATA to a Trunk Port then add it to a separate Line Pool, and then allow Remote access to this Pool. From the remote site dial the Destination code to access that Pool followed by *610,*62 or *630.