Depend on what is the objective.
if the idle-time out is too short, it will not convenient to some cases.
I used ISDN as backup , and I want it stay up until primary is back again.
in this case I put very high idle-time out. so it is not get disconnected until primary become alive again.
http://www.cisco.com/warp/public/103/12.html#2
I finally find out the real use of "bandwidth " Use of frame relay.
YiZhar said it right. it is only a label, nothing to do with actual bandwidth.
only for restrickting EIGRP routing update percentage of the bandwidth. nothing to do...
Benzito:
Can you tell us the exact config for blocking ICQ?
By blocking port numbers......it is not good idea.
Check point has function to block it...but did not work.
some one can help me with this?
Below:
Interface Serial 0.1
band width is 64.
1,that means this PVC can not burst over more than 64k?
2,what is the Max PVC-per-DLCI-Bandwidth ?
3, Is "frame-relay map ip xxx.xxx.xxx.xxx DLCI XXX" optional command...
what is loopback line means ? line???
if I ping the ip address of this S 0 interface....ICMP will echo to remote CSU/DSU and come back to S 0 interface?
Thanks.
I had exactly same problem before......
now you are in (boot)....
use command
copy tftp flash......
this will only work when your TFTP serveris correctly connected to Eth interface.
Defdault gateway of your PC(TFTP SERVER) is ETH 0 interface of your router.
find yourEth 0 ip address and use...
If I want to test remote loopback csu/dsu test on int s0,
where and what commands I have to issue?
Exmp: int s0
no ip address
int s0/0.51
framerelay dlci 51
ip address 10.1.1.27
int s0/0.57
framerelay dlci 57
ip address 10.2.2.2
Thanks.
If you know about upgrade of cisco 2610 DRAM, tell me about "Do"s and "Don't"s.
Is it just straight hardware plug-ins like any desktop RAM upgrade?
Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.