Can you check this out

[jasmjaso]

Can you tell me what's wrong or what I'm doing wrong. Look below

No usable interfaces
System Bootstrap, Version 11.0(10c), SOFTWARE
Copyright (c) 1986-1996 by cisco Systems
2500 processor with 2048 Kbytes of main memory

Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706



Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Fri 27-Dec-96 17:33 by loreilly
Image text-base: 0x01010000, data-base: 0x00001000

cisco 2500 (68030) processor (revision N) with 2048K/2048K bytes of memory.
Processor board ID 06277571, with hardware revision 00000000
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)



Press RETURN to get started!


%LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state to down
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
%LINK-3-UPDOWN: Interface Serial0, changed state to down
%LINK-3-UPDOWN: Interface Serial1, changed state to down
%SYS-5-CONFIG_I: Configured from memory by console
%SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Fri 27-Dec-96 17:33 by loreilly
%LINK-5-CHANGED: Interface Serial0, changed state to administratively down
%LINK-5-CHANGED: Interface Serial1, changed state to administratively down
2501A(boot)>en
Password:
2501A(boot)#copy tftp flash

System flash directory:
No files in System flash
[0 bytes used, 8388608 available, 8388608 total]
Address or name of remote host [255.255.255.255]? 192.168.200.26
Source file name? c2500-d-l.120-9.bin
Destination file name [c2500-d-l.120-9.bin]?
Accessing file 'c2500-d-l.120-9.bin' on 192.168.200.26...
Loading c2500-d-l.120-9.bin ... [timed out]
[failed]

2501A(boot)#dir flash
^
% Invalid input detected at '^' marker.

2501A(boot)#dir flash:
^
% Invalid input detected at '^' marker.

2501A(boot)#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Fri 27-Dec-96 17:33 by loreilly
Image text-base: 0x01010000, data-base: 0x00001000

ROM: System Bootstrap, Version 11.0(10c), SOFTWARE

2501A uptime is 3 minutes
System restarted by power-on
Running default software

cisco 2500 (68030) processor (revision N) with 2048K/2048K bytes of memory.
Processor board ID 06277571, with hardware revision 00000000
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

2501A(boot)#

 

[JohnJiang]

I had exactly same problem before......

now you are in (boot)....

use command
copy tftp flash......
this will only work when your TFTP serveris correctly connected to Eth interface.

Defdault gateway of your PC(TFTP SERVER) is ETH 0 interface of your router.

find yourEth 0 ip address and use that as your pc default gateway.


I hope this helps.

 

[jasmjaso]

Thank it did, I appreciate your help