Search results for query: *

kwing112000 did you get that config from your client this thing is killing me Thanks

Check the telephony tab under system inhibit call transfer isn't ticked

like all phone systems there are good points and bad points good engineers and lazy engineers All software has bugs depends on your use of the system you will have 10 customers on a level of software and 1 customer has major issue's it's all down to what you want or need from the system if...

i did this on friday last week do the 3.19999 and the 3.2999999 and once the PCS is ok you will have no issue's make sure you have the 3.1 software just encase

got calls in both directions call get answered for 8 seconds om both end and get drop at the answering side The doc above say that Compression is automatic and H450 support is none i think this is the issue any ideas out there guys The cisco is using G711 A Law H450 support i have...

Now i can dial the Call Manager no one pick's up the phone but it's going over the IP line Call From the call manger give me a busy tone Trace Log shows 84759609mS H323Evt: v=0 stacknum=250 State, new=NullState, old=NullState id=-1 84759621mS PRN: H323Sap::NullStateDLData --- Non-setup...

Tested this on an In house IPO to IPO and this works we have a ddi on system a going over scn to an IP handset and also chucked a DDI at a AA and we used the system short code worked 100% next step try this with the cisco

The call Manger is sending DDI to the IPO via H323 trunk and the avaya has an H323 Truck which should recive these calls and send to an ICR route to a User or a group I will check the Cisco routers/switches have the H323 fixups been removed

IPO - CM = ICOMP Disc disconect CM - IPO = BUSY

I'm using 412 with a VCM 8 and the IP Line show up as working in he new System Status software thanks Again

The cisco guy did his bit and i did the IPO configuration so the document was followed to the T and extension dialing giving icomp disc and the DDI pointing to the IPO gives busy Thanks

I have just started trying to link a Call Manager to a Avaya IPO. I have created the VOIP Line and tested sending all over the line i get an error Icomp Disc and the call is dropped before the configuration was done on the cisco i have a busy tone. the call manger calling the IPO gets a 100%...

yes there are a few modules drilled in the wrong place i use the ip 500 rack mounts on all the units but i have had to return a few drilled wrong

8N# im using

I'm trying to use voipcheap on my system the line is showing as active but i can't get any calls to run over this line using 8N sortcode