Please see error log below. I have replaced the power supply in what I think is cab2 to try and get rid of the BSD090 error, but the error is still coming. We have 3 cabinets, is the numbering of the cabinets 0, 1, 2 - 0 being the cab with the SSC card in it? Does this look like a NTDK23AA...
*********************************************
CS1000 RDB
*********************************************
TYPE RDB
CUST 00
DMOD
ROUT 5
DES QWEST
TKTP TIE
NPID_TBL_NUM 0
ESN NO
CNVT NO
SAT NO
RCLS INT
VTRK NO
NODE
DTRK YES
BRIP NO
DGTP PRI
ISDN YES
MODE PRA
IFC SL1
PNI 00001...
The first call was from my desk phone (1264) directly to a phone at the remote site (1316) that is forwarded to vm. The second call was from my desk phone to the main menu, then though dialed to 1316. The first call went straight to the correct vm box and the second did like a stutter ring...
It did work before, but we did do some cleaning up of ACDN's and RAN routes around the same time this started happening.
How could I check for CLID and TAT?
We have an Opt11 at a remote location connected to a CS1000 and Call Pilot through a tie line. Recently the remote location has noticed that when they forward their phones to voice mail and a caller comes in through the menu and through dials, they will be directed to the general mail box. But...
We have two PRI and need to record calls on one of them. Is there a way to route incoming and outgiong calls to certain extensions to go over one PRI?
Thanks
Just looking for some opinions on phone upgrades.
We still have 2006's 2008's and 2616's and I was wondering what the best option for upgrading would be, should we go to the m3900 series phones or the i2000's? We have a CS1000 and sig server so to add ip phones we would have to buy more...
Thanks,
FTTU is on the set
We used to have one dedicated ld trunk but now we have two local/ld trunks but never reprogrammed the ld trunk to be both. could that be the problem?
when a user forwards their phone to a cell number without the area code, the call will forward as long as the call comes in from the local area. If the call comes in from a long distance number, a message will say "We're sorry, you must dial a one with area code when calling this number" but if...
When a user forwards their phone to voicemail it works fine if the number is dialed directly. If the extension is chosen as a thru dial from our menu it goes to our "general" mailbox.
any ideas?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.