Search results for query: *

All sorted know so accept your peace offer.Thanks for your post for driver for NT4.The key is pressing F6 when setup launches then you specify install the driver then NT4 pick on the disk.If you o not do this when setup launches it will fail to see the disk after you created the logical drive...

I tried to get my head around what you have posted on my first post i clearly state i can see the controller so it is configured and can been seen.I required the driver for NT4 as it does not come with it that is what i was asking.My posting has not rude postings but if you have read my first...

Hi, All the HP DL Servers have hardware raid so you just configure the raid on P.O.S.T depending on how many disks you have in my case 2 disks which creates the logical drive 1.Then at this point put in the NT CD as it is a manual install and as explained on previous post this is how i got it...

Hello All, I found out that you have to press f6 then specify to install the driver the SmartStart version was 6.30 so i used the controller driver form 6.30.So you need to hit F6 when you see the SETUP is launching if you try to install after this you do get a option this is when it fails with...

Hello All, I am trying to build the above when i put my driver in it sees the controller but there after it says no disk found.I have used driver of the SmartStart CD and downloaded other ones.Can some let me know if they have a driver for NT4 which will pick up the 5i controller as any driver...

STKman, Which cable do you think may be at fault. When you mean put tape do you mean cover the lens on the camera. There is no maintenance. Thanks

Hello Forum, I am in a very sticky situation as my Storagetek 4410 crashed. Hand1 has a big issue on calibrating one of the lamps. Have swapped out lamp and did a long IPL but did not resolve the issue.So i replaced the complete hand still the same. Swapped over hands still the same issue in...

Yes as i suspected either the Head Asm or TCK card. The tapes used are different each day so this would rule the tapes out as error is there on different days. Thank you for your time.

Hello All, I have two 9490 transport for a Storagtek 4410. The following errors are been reported as below. FSC 3917 Read sequencer detected errors in too many tracks to correct reported as Read error. Does this look like a drive failure head ASM faulty or a card failure. Thanks

Many thanks this will be useful information. So konw i have a platform to work/Diagnose. Cheers

Hello All, I have a question i had a crash on the above this weekend When trying to IPL controller 4430 the following error were noted D0EA&C1B2 does anyone have a breakdown on what it might be or have a service manual with codes. Thanks

Many thanks for your input all seems to be fine. Will keep you updated if it does go down again.

Hello, This is the problem i was faced with.The libary just went down only FSC 6320 reported.I think it could have been a hand problem.As hand 1 had a blown lamp and it could have been doing somethin and could not read the bar code.So i replaced the lamp and did a long INIT everything seems...

Hello All, Yesterday the libary stopped working with the following error.i IPL the libary and is back up.I had a look at the hands there was nothing stuck in the hands.Do you think this could be a hand problem were both hands failed.Could anyone let me know What FSC6320. ACS 00...