Search results for query: *

Hello I have 3 servers connected to SAN sharing same volume and SL24 connected to the same SAN. We are trying to configure the SL24 jukebox with the EBS7 software but it is searching the SCSI path. Our SL24 has only FC ports, am I using the wrong version of software? Thanks

Hello All I have a question regarding the way the socket are created in solaris. to my knowledge a socket is uniquely identified by a 5-tuple. So I can not have 2 socket (with same protocol,IPs) listening to the same port on the same server. I noticed that I could create a socket with IPV6 to...

Hi You can use a web based application which does that, it is called dimstat. Regards

Thanks Annihilannic I ll give it a try and let you know Cheers

Hi I used vtsprobe which only check the health of the FRU. By the way I am using Solstice DiskSuite so can't use vxbench Thanks mate

Hi Annihilannic I have used this tool before but it doesn't really do what I want. I would like to generate a randomly (on different shared disks ) high traffic to validate the scsi speed of the 3320. It seems that there is an issue at high traffic which is caused by the scsi controller. all...

Hi Agree SVM is easy to use for mirroring. Stripping will be the best to use for performance that will reduce the I/O wait and for redundancy (RAID 0+1) if you lose one disk you don't need to resync the whole side of the mirror only the failed stripe Hope this will help

Hi I have 1 cluster T2000 + 2 3320 Storedge single bus. I would like to perform high load on the shared disks to test the performance. Do you know where I can find a free tool to perform this test Thanks for your help

Hi must likely there is a bad inode somewhere I recommend to do an fsck on your partition to fix your problem. If the partition is the one used from /, you may need to start using cdrom, then mount the disk and perform an fsck Cheers

Hi Agree, ipmp will be the right thing to use (previously nafo was used in solaris 8). But if you want a single IP address to connect to the Active node you will have to do extra work by creating a resource which will failover the IP over the new active host (in case of switchover). Cheers

Hi You should use luxadm command instead of cfgadm and proceed with the same steps described by Mike042. But unfortunately the iostat command will still report the errors for the old disk and only a reboot will get rid off these errors. Cheers

Hi check that the s bit is correctly setup cheers

Thanks for your answers It was working for one month and it stopped suddenly I have a bar coder but i don't use it Cheers

Good morning I am using Legato v7.0 on solaris 9 The problem is that when i launch my backup it fails immediately with these messages, can you please help me to solve this problem : 06/29/07 17:55:52 nsrd: amapmcp1:/osp/BACKUP/osp_bkp saving to pool 'Daily Backups' (DailyBackup.001) 06/29/07...

Thanks for the answers 605 that makes sense :) Cheers mate

605 Last question , what is the purpose of having a barcode reader though ? Thanks

605 Thanks a lot for these explanations cheers

Dear All I have a question regarding the Label of Tapes When you Label a tape does Legato right something on the tape such as the volume name/pool etc... The reason why i am asking that is because i don't know how Legato can recognize a tape without a barcode reader when you insert the tape for...