You are going to have to duplicate the RDD. If there is a parameter that you will need to pass to the RDD, then you will need to Duplicate the RDD, and create a BAQ to call the RDD. The BAQ Report Designer will allow you to prompt for parameters.
Thanks
I have a DoCmd.RunSQL that when the event is fired off I get a message box inside access that says "Your about to update 1 row.." blah blah.. is there a way to remove that box from popping up on that event?
Jon,
If you tell me the scanner module, I can tell you how to set the carriage return. Normally the scanner comes with documentation, and in that documentation is a barcode that you scan that activates the carriage return. If you give me the make and model i will try and point you in the right...
I get this message "Telephony programming is currently not available. Please Try Again Later" when im in the Unified Manager, I click Services, then Click Telephony Services.
This is where i used to go on 3.0 to change the display name on the sets, and to set up other features on the sets.
I received a 50-1 Alarm, after receiving it none of the features worked and the phone system for the most part stopped working till it was rebooted. Does anyone have a clue as to what the 50-1 Alarm is?
Im running BCM Version 3.01
Thanks in advance
I have a BCM 400 with BCM 3.0 installed. I was wanting to see if I could get it upgraded to a newer version of the software. Any thoughts would be extremely helpful.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.