Search results for query: *

Sorry folks, I've been away at training for a few weeks and haven't had time to get back to this particular problem until today. I appreciate all the suggestions and have tried everything and have come back with this CLI capture and a couple of screen caps. I'm concerned about the health not...

Has anyone had any success with configuring NTP on a CS1000M SG to sync with a single external NTP server? I've been going round and round in circles and it doesn't ever update the call server time even though the base manager and element manager time is correct. This was a lot more straight...

Yes, that is normal. It will only return a status that the request was sent. From past experience that has always meant success.

Graceful or Forced, makes no difference from what I've seen, the difference of 30 seconds maybe. Same result either way.

I have a scenario where messages are reappearing over night for 3 users connected to a BCM50 which is H.323 trunked to a CS1000M MG Rel 5.0 with a CallPilot 201i Version 5 on SU07. It's just these 3 users out of 12 on that BCM50, and this is one BCM of many that are H.323 trunked to the same...

From UCM, click on IPSec, change IPSec required to "No" for all devices, Synchronize and Activate. That should pass the token you need to continue.

Have you tried using a different terminal device or connecting with a laptop/PC and a terminal emulation program? Proper serial settings to connect should be 9600,8,N,1,VT100/VT220.

Are you replacing like for like VGMC? If it's the same P/N you can take the CF from the old one and use it on the new one. It contains all the software and settings you need. Just remember to change the MAC address of the ELAN interface in Node programming and retransmit the node information...

Check your transport type for each endpoint in NRS. BCM can only use UDP, where a CS1K can use either TCP or UDP. Change the CS1K to use only UDP in both the node programming and in NRS and see if you are able to place calls.

How do you set an IP set back to Factory Defaults? I'm not able to locate in an Nortel docs, unless it just doesn't exist.

Thanks biv343, yes, the BSR222 does have the option to enable NAT Traversal like the NVR. I enabled it during the config for port 10001. Problem still persists.

I've recently put a BSR222 into service after configuring it in a lab and testing it with actual IP addressing and IPSec settings. Both client termination and BOT worked properly before leaving the lab. Now, when trying to connect remotely, the Nortel VPN client (ver. 7.01) appears to connect...