Search results for query: *

Funny we aren't using IP, convince me it is reliable when out network goes down every other day

We have almost 30 T1's. If your board test fails, take a jack and strap pin 1 to 4 and 2 to 5 and unplug from the network and plug your cable in, then retest your board it should pass but test 143 is historical and might show an error

I can't find an implementation that shows how our CDR is configured with an 8400B module and a 2 wire digital port. i asign the data module as a PDM and it tests okay but my switch will not link up and I get the inverted red and green lights which means the 8400 doesn't see the switch, what...

Thank you for the reply. I changed the rectifier last night and still had the power alarm in the cabinet and the fans were going on high. Well this morning about 8:30 the fans slowed down gradually and the alarm went away. All good to go. Thanks again

Okay the documents only tell you how to test. I fail test five error code is 8

I replaced the batteries and thought they were the problem. After testing I find each battery is around 50 Volts DC. Upon further testing at the 250 V rectifier, I find with the batteries disconnected I read minus 35 Volts and in the two othwer cabinets I read approximately 215 volts DC with...

The batteries have been installed for weeks and still the voltage remains low.

I have a power alarm in cabinet one. I replaced the batteries and the voltage reading will not go above 157 volts. My vendor claims avaya does not warranty the batteries. Is there a way to increase the battery voltage without smoking my switch.