Search results for query: *

Feature 819 only works on a per call basis. It turns itself off after one call or a little bit of time.

I looked at CSU but it only had 0, 7 and 15 db settings? They all appeared to be gain and did not seem to get rid of the problem?

I have a PRI that on occasion has echo on some calls. I have heard it. I saw on a previous post that you can change a setting in CSU area. I normally haven't turn on CSU, but understood it would give you a way to know if there were any clocking issues and faults etc. Should I just turn it...

One solution that may work for you is if you instruct your people who wish this not to happen to them is to have the use exclusive hold. By pressing the feature key first and then the hold key, the call will remain held on their set indefinitely and will not go back to prime.

4.1 mignt require a minimum 2.0.10 software card on the flash voice mail! to be seen

Just to add, by implementing Auto Attendant on the CICS, I managed to get the BCM Dialing directly to the extensions. I still have the problem with dialing into the BCM from the CICS in that invalid extensions just hang in silence until 3 minutes, and then they go to a fast busy? Any ideas...

I've spent a pile of hours messing around with the programming and trying to tie a VOIP gateway between a BCM1000 with VOIP trunking and a CICS 7.1. Three problems 1. In calling into the CICS, with the trunks set to autoanswer (with or without DISA) all calls go to the prime set? 2. When...

I've got a BCM 1000 3.7 (with 4 VOIP TRUNKS) connected to a MICS using a nortel 4 port gateway. The problem I'm having is that although calls can be made back and forth, when I call from the nortel into the BCM, the invalid extensions do not give a busy signal, instead I get dead air? I can...