Search results for query: *

where can I find a copy of DSA 2.0

thank you for your info

where would I find a list of Definity common control cp's for all the releases.

what is needed to upgrade a g3v6 to v7 or v8...a processor change or netcon card....any ideas..thanks

are you refering to the ox16 mlx or the 0x16 t&r pack. what release of ti card is the 517m15.

anything special I need to know about installing a PRI ckt. what to look for....possible problems...etc.

Now for the next set of q's. If the customer I have wants to change from the 2way-DID T1 to a PRI...can I use the same 100d card and I did notice a set of parameters to program for the PRI ckt. Will I have to remove the translations of the T1 first. I have never installed a PRI ckt...so any...

got it...thanks for all your help!!!!!

so with the PRI ckt...there is no extra programming for Call ID...it automatically starts.

as far as I know it is a T1.

2 way DID

With a PRI ckt...any special programming needed to get Call-Id...or does it automatically send the call id info to the sets..my customer has a At&t T1 ckt used for DID's. Right now no call id info is being sent...At&t says their ckt should be doing so....any ideas..thanks. The switch is Legend...

thanks for your info...good stuff...I suspected as much... I prefer the Legend way of doing restores.

Is there some golden nugget of info on how to take R3 backup translations and attempt to restore to a higher release processor.

The Merlin 410, 820 series required 4 pairs...if you did not care about the voice over the IC...you could get away with 3 pair.

thank you for the info....what has me wondering about is this system has been up & running for a couple of years with no problems....It could have taken a power hit and damaged the procresor...one other little note..I started having trouble w/ RA...I changed the backup/modem card and still same...

I have a ACS 4.0...w/ vm nite service controlled by the NS button on the console....problem is lately when the button is set for NS...it appears like the system is Not in NS....we have reseated the processor mod and it seemed to clear the problem for awhile....now its back...I suspect the...

I think a processor change from r7 to r3 or 4 might work. I have had no trouble in the past with the upgraded cke3's. However this customer uses the IC/HF feature more than most. this might be a clue....I'll post the results. thanks for your input.

its a ATL pack....the stations are programed for BIS/HFAI. the problem is that when a caller uses the IC to talk with the other station...the voice cuts out and the IC drops. Yes the HFAI button is on the called set. any ideas???

Anybody run into this one.. Using a cke3 upgraded to 7.0142 and analog ckt packs w/ HFIA sets...when using the IC to call another station the responding voice cuts out and the IC hangs up. No particular station set is the culprit. We have replaced the 4x8 cp with no success. The PS is A3. Any...