Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. rodoftex

    continuous vectoring

    I use Corel primarily for laser engraving. My problem is that the engraver apparently performs the vectoring in the sequence that the design was done.ei, during the design or layout of an object the designer will draw a line segment here and another there until the design is complete. When...
  2. rodoftex

    "master guideline problem

    That was the problem, the layer was locked. That solved my problem and I thank you very much.
  3. rodoftex

    "master guideline problem

    The object docker was open but I'm not sofisticated enough on the program to know to know if the layers are locked.
  4. rodoftex

    "master guideline problem

    I am using v.12. Have tried dragging to another layer but no luck. I very well may not be doing it correctly.
  5. rodoftex

    master guide lines problem

    thanks vacunita. I have reposted.
  6. rodoftex

    "master guideline problem

    rodoftex (TechnicalUser) 24 Mar 06 7:00 Somehow during the development of a project it got put on the "master guidelines layer" of Corel Draw. I am unable to extract it and get it back on layer 1 and can't print it (laser engraver) as is. I have a lot of time invested in this project and hate...
  7. rodoftex

    master guide lines problem

    Somehow during the development of a project it got put on the "master guidelines layer" of Corel Draw. I am unable to extract it and get it back on layer 1 and can't print it (laser engraver) as is. I have a lot of time invested in this project and hate to start all over. Any help would be...

Part and Inventory Search

Back
Top