Somehow during the development of a project it got put on the "master guidelines layer" of Corel Draw. I am unable to extract it and get it back on layer 1 and can't print it (laser engraver) as is. I have a lot of time invested in this project and hate to start all over. Any help would be appreciated. thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
master guide lines problem
- Thread starter rodoftex
- Start date
You should probabl;y post this in the Coreldraw forum as it is where it most likely will get thwe best response.
Here is the Corel Draw Forum: forum238
----------------------------------
Ignorance is not necessarily Bliss, case in point:
Unknown has caused an Unknown Error on Unknown and must be shutdown to prevent damage to Unknown.
Here is the Corel Draw Forum: forum238
----------------------------------
Ignorance is not necessarily Bliss, case in point:
Unknown has caused an Unknown Error on Unknown and must be shutdown to prevent damage to Unknown.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question