Hello JoeNewton,
Refer to page 3 of the release notes of the patch zip file:
To close both vulnerabilities, as per the mitigation steps (Log4j – Apache Log4j Security Vulnerabilities ) provided by the Apache, JndiLookup class is removed from the log4j V2.12.1 libraries used in the...
Hello All,
After some back and forth between support teams, the case was escalated to a higher tier of PLDS support and the licenses were re-issued (count mapping corrected). Thank you for all the helpful suggestions. Z
JoConnex--thank you for the reply. I'm actually looking for a total of 16 additional PRI (total of 24 with the 8 already on board) since the PLDS entitlement line item is 8 counts of "IP OFFICE R10+ IP500 T1 ADD 2CHANNELS ADI ENTITL MIGR LIC:CU."
Hello All,
I recently upgraded a two site IPO 500v2/SCN solution from R9.1.12 to R11.0 FP4 SP4. When I applied the PLDS license to each unit, a strange thing happened--Voice networking (VCE) and PRI channel entitlements/counts came up short compared to what PLDS portal was showing. For...
From a very old doc:
"Use only Lucent Technologies 4400-Series telephone Auxiliary Power Supply Unit (PEC 4499-
PWR, comcode 108596412) with the 4424LD+ telephones or with the 4424D+ (when connecting
a DSS 4450).
OK--it's SIP trunking to a call manager environment. But the VG2xx parts of such a solution aren't stand-alone (i'm guessing), so re-using the VG2xx components won't be an option. Any preferred/IP Office-friendly pieces to get 16 - 24 analog ports out to a remote location served by a fiber...
Hello all! Would a connection from a 500v2 to a Cisco VG224 analog gateway device require SIP trunk or 3rd party IP endpoint licensing? Thinking one of you has run into this...Thanks! Z
Has anyone had the pleasure of swapping out a bad drive (solid amber light) on a Server Edition DL360? Since the drive in position 2 is still good (and server still up), will the replacement be as straightforward as hot-swapping a replacement drive that is the exact same piece of hardware...
Here's the first few lines of a settings file that I set up that provided a solution to bypass that prompt on a configuration I did:
## VPN Settings for 96xx VPN Phones to work with Sonicwall Firewall
## VPN Mode=Enabled
SET NVVPNMODE 1
## Profile Password
SET NVVPNCODE 876
##VPN user name
SET...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.