Search results for query: *

vdan, I don't really know is this thread can help you: http://www.tek-tips.com/viewthread.cfm?qid=1179068 I found to send different CLIDs through different PRIs. Regards, JJF.

Hi friends, if anybody suffer an error SCH3139 (Cannot copy a digital voice TN to a digital data TN. Also, you cannot copy a digital data TN to a digital voice TN). When you are trying to copy a digital telephone on LD11. The reason in most of the cases is the presence of CLS FLXA. The...

John, I found the solution. On the RDB I changed the RCLS from EXT to INT; Changed the ISDN CPFXS from NO to YES and then I inserted the HNTN with my "GSM" preffix, 5. In this way, I'm sending the calls to the supplier in the correct way. DCH 11 UIPE_OMSG CC_SETUP_REQ REF 0000012E CH 1 29...

3tdp33ler, on other post I recommended SJPhone. I cannot guarantize if it's SIP compatible, but I tested as H323 against Nortel Meridian ITG Trunk and worked fine. Regards, Julián.

John, I thought that Calling number was the same than CLID. Probably I missunderstood it. The solution with two PRIs is very nice but little expensive. I am thinking to use an UDP number built on (HLOC + DN) -I saw on the manual-, but I don't know which LD is the one to create UDPs. To...

Hi, my GSM supplier offered me to link my PBX with its GSM network through a T1 PRI link. They required me to identify the CLID as 5xxxx where xxxx is the internal extension number. In the other hand they cannot help me on how to configure my Nortel M11. My current configuration is the...

Hi all, I successfully tested the SJPhone softphone against a Nortel ITG Trunk card. I filled the IP address of my Meridian ITG card as the softphone gateway. You can download at http://www.sjlabs.com/SJphoneWin Even, it can receives calls but only with a fixed IP address. If you need more...

Another option is to use the CALL command on LD36 PBX asks you for the DN to dial. Julián Fuertes DHL Aviation Madrid, Spain

teekow when you said on previous post to split the trunks. DId you say to divide channels or physical cards? I have only one card at one site and I would like to "speak" with other gateways, like Patton SmartNode. Currently, the configuration of my DCH and the ITG are on SL1 status. I tested...

John, I fixed it changing the CLID to Yes under PARM data on LD17. I got this info from another thread. In any case, thanks a lot. Julián.

John, I have a similar problem. I have package 151 enabled. MSGI shows incoming CLID, CDR_DATA has CNI as DGTS and RDB has both CDR and INC set to Yes. Thanks for your help, Julián.