Search results for query: *

Did you make sure that you loaded BOTH drivers for the Autoloader? There is a driver for the actuial LTO-2 tape drive AND the Autoloader. If you missed the one for the drive you will be able to see the tapes and move them around but not much else.

I need answers to a few questions with this version. I am using this in conjunction with a Dell 122T LTO-2 autoloader. 1. How do I make BE see the tapes as 200/400G tapes. Best I can do right now is 100G 2. How do I get BE to overwrite a tape WITOUT asking if I want to overwrite the tape! I...

Thanks I will try that. I was looking for a way to get in using a GUI interface, over TCP/IP. Any Recommendations?

I purchased a Nortel 5510-24T and it came without any documentation. Can anyone tell me how to get into this switch? A method to reset it to base config and how to connect to it to configure it would be a big help. Thanks Techlord

Yes I tried the regulation cross over cable is there a specific cable pinout for Cisco between 2 of their devices?

I am trying to connect a Cisco 2600 PIX and a Cisco 1721 router together for added translations. Can anyone tell me the correct cable pin out to connect the 2600 ethernet out to the 1721 Ethernet) input. I have already tried a standard cable and a crosssover cable but I cannot ping the 2600...

Ok I am a total dummy here, I am used to the NEtopia routers. I have SDM 2.1.1 how exactly do I add a default route and what settings do I tell it to use?

I have a Cisco 1721 Router, with an internal FastEthernet0 port and a WIC Card Ethernet0. I have the FastEthernet set as the internal Ip address of 192.168.0.82 and the Ethernet) set as the external of 12.145.4.98 I am connecting my external Ethernet0 to the ethernet input for a Cisco 2620...

Below is the Configuration that I got after connecting to the Router thru the HTTP:192.168.0.1 I am able to access the router but not load the SDM software since it keeps tellng me it cannot locate the router. Any help is appreciated. ------------------ show version ------------------ Cisco...

Below is the Configuration that I got after connecting to the ROuter thru the HTTP: I am able to access the router but not load the SDM software since it keeps tellng me it cannot locate the router. Any help is appreciated. ------------------ show version ------------------ Cisco Internetwork...

My router doesn't have a eth0 it uses FastEthernet0 I set that to 192.168.0.1 I can access the router thru http://192.168.0.1 and putting in the level 15 user name and password. I run the SDM install and use the same info to connect to the router and it fails trying to find the router. Any...

Gentlemen, I purchased a Cisco 1721 used from Ebay. I know that was my first mistake! I need to get it back to factory settings so I can configure it to allow SDM to load. Can anyone tell me how to reset? I would appreciate any help on how to configure to accept the SDM afterward as well. I am...

I checked the MTA limits as well and they are set to No Limit. I have EMP5.5 as an incoming mail SPAM Filter but no other SMTP Servers.

I am trying to figure out why I am recieving this message. 552 4.3.1 Message Exceeds Fixed Maximum Message Size, when I try to send a 1.6MB file. I have looked at the Exchange Server Administrator, under the Internet Mail Service and the limits are set to No Limit. I have checked the...