Search results for query: *

I´m looking for burning software, which is running under HP-UX 10.20. I would use it with CD-R (700MB) not with DVD. A data compression would be fine. abbysux

It doesn´t help. Noting changed abbysux

Hi Patel, I did the folloing so far I read in the HP-Forum : create a file e.g /tmp/change_instance with the content of the new HW-Path and the desired instance numbers. 10/1/2/0 lan 1 10/1/3/0.3.0 tape 0 My old HW-Pathes were ( for your information ) 10/1/2/0.3.0 for the tape with instance...

E.g. I had a network card in slot 2. The ioscan shows me the instance number 1 and the command lanscan shows in the column “Net-Interface Name Unit” - lan1- which I would normally expect to see. In slot 3 I had an scsi single ended interface. The instance number was 1 and I can use the...

Hi icreek, After editing the /etc/inittab file, reboot the system. I am not sure if init q is enough. Regards pgl222

check the PPID and if it is possible kill this process kill -9 <PPID>. The defunct process will gone

If you have a good Ignite Installation and you have all Patches. Boot in the single user mode. # /etc/shutdown -r -y now Terminate boot proccess Use b pri isl ISL Y hpux -is /opt/ignite/bin/make_recovery -A -v makes a full ignite of the boot disk. But this makes only sense if the disk is not...

In the meantime I have found my own solution for the problem, but it is a much longer process than your way. Thanks for the help, I really appreciate it. Here my version: After installing a new HD (e.g. /dev/dsk/c2t5d0 was bad) reboot the system 1. Free pysical extends. # lvreduce...

It´s not possible to use only SAM for mirroring a disk. I had only success by using the commands in a shell. 1. pvcreate -B -f /dev/rdsk/c2t5d0 2 .vgextend /dev/vg00 /dev/dsk/c2t5d0 3. mkboot /dev/dsk/c2t5d0 4. mkboot -a &quot;hpux -lq&quot; /dev/dsk/c2t5d0 5. mkboot -a &quot;hpux -lq&quot...