Search results for query: *

I'm currently running S8720 CM 3.1.2. I'm trying to configure an ISDN BRI for a radio station to use for a temperary broadcast. I currently have a TN2198 with U type interface. Is this as simple as adding a wcbri data module. I want to test with a Polycom Video conference device that I have...

Thanks TB, The problem I had was not using the real server address on the RPM page. I was using the active server address. Its working now.

My company is installing the new 9600 series telephones. I have been told the 8720 can serve as an HTTP server for firmware for the 9600 series. I have loaded the settings file and upgrade script on the 8720 and its working properly, and I can see the firmware in the /tftpboot directory but...

I just had this problem. If the new batteries didn't fix the problem, replace the charger, or swap the charger with one in another cabinet. Note: connect the new charger and turn it on befor you connect the last battery. You will hear the relay open once the last battery is connected. If that...

You were CORRECT! Thanks for your input.

I added an h.323 trunk group between 2 8700's. The 2 systems are connected via h.323 over an MPLS circuit. The trunks are inservice idle. When I list trace tac on the far end server, I see the call set-up take place; however, I get a denial code in CM. The phone rings on the far end, but no...

That was the perfect answer. I got it. Thanks a ton.

You are saying go into my mailbox from my desk phone and perform what procedures? I have already added my mailbox as a contributer for this listen only mailbox. These octel duties have recently been thrown into my lap, I cut my teeth on Intuity. Thanks, FH

I'm trying to record a message for a listen only mailbox in a type 31 attendent. After recording the message as a type 1 mailbox. I play it through the attendent. I here my newly recorded message plus I hear in addition "there are no new messsages waiting, please try again later, thank you"...