Search results for query: *

quick question. MICS 6.1XC NAM 4.1 upgrading to 7.0XC should i leave the Nam powered down until the Mics is completed with the upgrade or power them up at the same time

am using COS 7 or 13

system: 4.1 mics voivemail: 4.0.04c outbound transfer and off-premise notification was working just fine. customer had a different vendor to upgrade the software to XC. Did not receive any reports of a problem with the transfer/notification until last week. built new mailboxes and they will not...

client has a email server ranning a POP3 email software. we will be connecting the voicemail to this server. i remember reading in the posts that you could send the voice messages to a POP3 email account with the CP150, but i can not find the post now. this is for a police department and they...

i know both the NAM nd call pilot support desktop messaging. the question i have is, will both support sending the voice messages to a POP3 email account?

1. can a NAM voicemail with desktop messaging have their voice messages sent to an email server POP3 software? 2. will the above work with the the call pilot 150 with unified messaging?

was having a problem with voicemail ports shutting down.replaced card and no problem so far. Evt's fill up maintenance log in about 2 minutes. Thank's for info.

I have a NAM running fax messaging software and desk top messaging. I receive continuiosly EVT 609 and EVT 995 in my telephone system log. 1. what are the evt messages 2. How do i correct

I have other 4.0 voicemails that we have programmed for outbound transfer, message notification and DID's direct to Guest mailboxes. I have had no trouble with these voicemails unless the voicemail was working with a MICS 5.0. I know if I have a MICS 5.0, upgrading the voicemail to 4.1 will not...

Unforutanly i did not install or program this system. I am working with a system installed by "as the client said" someone that did not know much about it. They are not using message notification and never have. We setup the CCR Tree for 1 digit external transfer to their answering service. We...

I have a NAM's Voicemail 4.0.04C with 14 channels. Four are available for outdial. The first outbound transfer will go thur. The second and third outbound transfers get a "party not available or busy signal", and the process begins again, 1 out next two no go's, 1 out next two no go's etc. I do...

AS far as I know the NEC is dialing a access code to get access to the 8 T-1 channals. If I have a pooled group button programmed it will ring the pool group. If I remove it from a pool group, it rings to staion 10, if the lines are assignned to it. I do not know if the NEC is using ARS/LCR for...

Unknown, the way we got it to work was the NEC set up access codes with the ext # included for each channal. I then assigned these channals as private lines to each phone. Problem with that is you can not share channals, If you are on your channal you get busy thanks for the reply GM

I have a ACS r6.04. The upgrade T-1 problem patch has been installed. System has been programmed with the channels programmed as DID. The DID mapping table has been programmed. We can access the point to point T-1 and call into the NEC system in Michigan. The problem I have is when the NEC...