Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. wdmeche

    Option 11C, Peripheral Cards Fail to Enable on SYSLOAD or INI

    In the future be very careful seating daughter boards. They are tricky and very easy to snap or misalign. I had a similar problem with one that was interfacing with a property management system.
  2. wdmeche

    clicking sound on handsets

    Do you have this problem with other IP phones on the system? If so the set up could be off on the network side. Not prioritizing the voice usually leads to choppy conversations. I have WAY more TDM experience than VoIP. I would think that if it is provisioned correctly then it is the card.
  3. wdmeche

    NXX not working

    I am trying to figure out why an NXX is not working in and Op 61 with two PRIs. When you call it from this location you get the carriers recording that you do not have The NXX was added by someone else, but it looks like all of the other local numbers in the switch. I tried this number from...
  4. wdmeche

    Disconnect on analog line

    Ok, last one, an analog trunk connected to a People Finder voice pager disconnects when the DN is dialed from the inside, but when you call from outside and go through the auto attendant the voice pager gives you the "go ahead" tone to dial your pager number. If you call from the inside and not...
  5. wdmeche

    SRPT118 code

    I recently had an OP 61 suffer a lightning strike. I got the two effected superloops back up but now I am gettin a SRPT118 CM: Server connection lost, and a SRPT117 CM: Server connection established. right after if. I also get a SRPT110 CM: Primary client connection established message...
  6. wdmeche

    CONT - 2 card error

    I recently helped enable an OP 61 that had a power supply go out. After we replaced it the CONT - 2 card was disabled. I went into LD 32 and enabled XPEC 3 and the card came up along with the line cards on the shelf. The only thing is now instead of flashing CO 03, it is flashing C8 0B at...

Part and Inventory Search

Back
Top