Search results for query: *

Hi, On an 805 router the max supported bandwidth is 512Kbps. If you need to updgrade to a 2Mpbs circuit, I guess the best and the most cost-effective method would be to go in for 1601 router. This can support upto 2Mpbs.

Seems to me as if fast switching has been configured on your router. Most routers have fast switching enabled. The problem with fast switching is that it load-balances on destination basis. If you want equal cost load balancing, you could try ip ce, or what u could do is configure a multilink...

Hi Jimmy, Thanks for the response. The current IOS in the router supports this card, I have verified from the software advisior on the Cisco site. Also this card has been installed a long time ago. From the 3600 memory calculator i confirmed that the Flash, RAM and the IOS feature set are all...

Hi all, I am getting some the error mentioned below on a 3662 router, Sep 24 23:27:29.202: %CONTROLLER-2-FIRMWARE: Controller E1 4/0, firmware is not running What does this error mean? I went through Cisco's web pages ,and all it does is tell we that its either a software/hardware issue (as...

Hello, I have a strange problem. Before i start lemme give u the specs of my router Router:3662 Flash:32MB DRAM:96MB AIM Plus card IOS:12.2(15)T5 IP/FW/IDS PLUS IPSEC 3DES Now the problem, since the day this IOS was upgraded, we have not been able to get connected using ISDN. ISDN here acts...

Hi, You could check out the "T1 Survival Guide" by O'Reilley. The book is about $20, and gives you a the history, development of the T-carrier sytem, the framing formats, signalling, common errors etc. I have found it to be pretty useful, even though here in India we use the E-Carrier...

Hi, I have a Cisco 3640 with ISDN BRI as backup to the primary leased circuits. The ISDN has been configured using dialer profiles. The problem I am facing is that I am trying to monitor ISDN connectivity using the ifOperStatus value (OID 1.3.6.1.2.1.2.2.1.8.X). The value of the ifOperStatus...

Thanks svermill, can you suggest some reading material for the same.

Thanks Lucas, You were very helpful. I too think that the LOS was present as there was nothing connected. However we have two modems here, both with the g.703 interface, one of them shows the LOS while on the other the LOS lamp is not lit.......hence the confusion.....and to add to...

Hi I need some info on RAD ASM 20 leased line modems having the g.703 interface. On these modems there is a lamp labelled LOS, what does LOS mean, and when the modem in not connected to any network, i.e say i am testing it, should the LOS lamp be lit. The modem someone said was faulty, but when...

Hi, The question may seem stupid, but i do want to know what is the need for WAN encapsulation (HDLC, PP etc.). Is it there only to distinguish between frames, provide synchronisation and provide CRC error indications, or there some other reason. Also when a router prepares a packet for...