Search results for query: *

Just to update this thread, I ran some file recovery software on the drive (get data back) and was able to recover a restore point from an previous partition (about a year old) after renaming and then dropping these into the system32\config directory the pc now boots fine and i can access all...

Thanks Linney, tried chkdsk /r but its definately the reg file which is the problem, i have copied it and checked it using a program called regdatxp and could possibly recover about 25% of it using this program, my main problem is that there were lots of thumbnails available in photoshop...

Yes Method 2

Hi Linney, thanks for the reply, unfortunatly there are no system restore points on the pc, i cloned the drive and attempted to do a windows repair setup but as soon as windows setup does the "checking for existing version of windows" part, the computer resets itself probably due to the corrupt...

Hi, I need to repair a pc with a damaged or corrupt "software" registry file, i have copied the software file from the windows repair directory and can now boot the pc ok, however i need to repair the damaged file to enable my programs to run since some of them contain settings and data which i...

Hi, I have soho 90 series adsl router and need to use it to accept vpn connections from pc's running the cisco vpn software, the router only supports crws and Iam having problems finding instructions on how to do this, all the info i can find seems to suggest that the "easy vpn" feature is only...

Hi, I have copied the following config into a new 837 router using the hyperterminal copy and paste method but am now not able to access the router using snmp or telnet, I can still access it from the console connection and have tried new community strings but the problem remains, the document...

Thanks, sorted it, I should have issued the no shutdown command on Fastethernet1 during the password reset procedure (I only issued it for ethernet0) :)

Hi, I have tried the router connected to a Netgear hub and also connected directly to my pc's network port.

Hi, I have done a password reset procedure on an 837 router and have issued the no interface shutdown command on ethernet0 before writing to memory as suggested by the cisco docs, however when the router is first switched on the lan light is lit until the router is fully booted but then it goes...

Ok, I will have a go the next time Iam over there, thanks for the help.

Thanks, I used a program from solarwinds to download the config and upload it into the new router without problem (still to test it though). Again on a similar subject we have to do the same for the router at the branch office but all attempts to access it have failed, we do not know the...

Hi, i need to configure an 837 adsl router to replace the existing router in case of failure (as a backup), we have a remote office which connects to our network through a vpn connection which is presumably "nailed" up through the routers (the connection works without using the client...