Search results for query: *

Telnet traffic is enough as interesting traffic to activate ISDN call?

Depend on what is the objective. if the idle-time out is too short, it will not convenient to some cases. I used ISDN as backup , and I want it stay up until primary is back again. in this case I put very high idle-time out. so it is not get disconnected until primary become alive again.

Thanks for the help svermill. It is true "bandwidth command " regarding OSPF....etc Thanks sgain.

http://www.cisco.com/warp/public/103/12.html#2 I finally find out the real use of "bandwidth " Use of frame relay. YiZhar said it right. it is only a label, nothing to do with actual bandwidth. only for restrickting EIGRP routing update percentage of the bandwidth. nothing to do...

Benzito: Can you tell us the exact config for blocking ICQ? By blocking port numbers......it is not good idea. Check point has function to block it...but did not work.

some one can help me with this? Below: Interface Serial 0.1 band width is 64. 1,that means this PVC can not burst over more than 64k? 2,what is the Max PVC-per-DLCI-Bandwidth ? 3, Is "frame-relay map ip xxx.xxx.xxx.xxx DLCI XXX" optional command...

I would like to loop my side loop to remote CSU/DSU. My site is A, remote site is Z. What command needed and "how to" test it? Thanks a lot.

what is loopback line means ? line??? if I ping the ip address of this S 0 interface....ICMP will echo to remote CSU/DSU and come back to S 0 interface? Thanks.

share your secret with us please. how did you solve the problem? thanks

I had exactly same problem before...... now you are in (boot).... use command copy tftp flash...... this will only work when your TFTP serveris correctly connected to Eth interface. Defdault gateway of your PC(TFTP SERVER) is ETH 0 interface of your router. find yourEth 0 ip address and use...

Hi Nicole: I have similar ISDN problem. can I send you my configs to look at? thanks

If I want to test remote loopback csu/dsu test on int s0, where and what commands I have to issue? Exmp: int s0 no ip address int s0/0.51 framerelay dlci 51 ip address 10.1.1.27 int s0/0.57 framerelay dlci 57 ip address 10.2.2.2 Thanks.

If you know about upgrade of cisco 2610 DRAM, tell me about "Do"s and "Don't"s. Is it just straight hardware plug-ins like any desktop RAM upgrade? Thanks.

I have checkpoint firewall-1 and VPN installed..... can anyone show me basic config on policy editor inorder to make secureclient access ?

I have checkpoint firewall-1 and VPN installed..... can anyone show me basic config on policy editor inorder to make secureclient access ?

Can anyone tell me the exact config of port mirroing? I want mirror port 1, and my sniffer is plugged into port 2 thanks