Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. geemul

    Ping & Trace Route from inside a PIX firewall,

    Ok, now I see my error! I haven't configured NAT! Thank you very much for your help. Geoff
  2. geemul

    Ping & Trace Route from inside a PIX firewall,

    Hello, Thanks for the reply which definitely answered the questions as I asked them! Unfortunately after reading my questions I realise the way I worded them was quite ambiguous . What I want to do is be able to ping and run trace routes to hosts on the internet from clients on my protected...
  3. geemul

    Ping & Trace Route from inside a PIX firewall,

    Hello Team, I wish to be able to ping and trace route from within my network protected by both PIX506e and 501 routers. I also wish the routers to ignore ping and trace route's originating from the internet. What do I need to do in the setup of the devices to achieve the above? Thanks, Geoff
  4. geemul

    Accessing PDM on 506E

    Thanks fishmahn, Thanks kmills, I rolled Java back to 1.4.0_01 and PDM burst into life! Geoff
  5. geemul

    pix 506e stops displaying after PCI Device table is shown

    My 506 will freeze at exactly the same point if I don't have any cables connected to the Ethernet ports. Try joining the two Ethernet ports together with a crossover cable and reboot the PIX. Geoff
  6. geemul

    No IP assigned to Outside on PPPOE Connect,

    Well, I defaulted the PIX to factory settings and started again. Now it works! No idea what happened there, now to get PDM working! Geoff
  7. geemul

    No IP assigned to Outside on PPPOE Connect,

    Hello, I'm setting up a 506E to do PPPOE over a transparent bridged xDSL modem to connect to my ISP. I used the sample config from here and the Cisco manuals: This is a sample PPP over Ethernet (PPPoE) PIX/ASA configuration: vpdn group pppoegroup request dialout pppoe vpdn group pppoegroup...
  8. geemul

    Accessing PDM on 506E

    Hello, I'm currently configuring a 506E and was wanting to have a look at PDM. I've created an username of "admin" with access level of 15 and a password. I can seem to connect to the 506E with IE 8 and enter the above username and password succesfully. I only get the attached screen capture...

Part and Inventory Search

Back
Top