Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ledfordb

    Need Vodavi XTSc cabinet ASAP

    Does anyone have a Vodavi XTSc cabinet that I can purchase? I have a client site that is out of service and need this part yesterday..... If you have one that you can part with, it would be most greatly appreciated. You can contact me via cell at 423.593.3223 Thank you.............
  2. ledfordb

    Elite IPK and Paetec Dynamic IP SIP Trunking

    Client has an NEC Elite IPK with CPUI(300)-U10, which originally had a PRI installed and worked flawlessly. Client was talked into converting to a Dynamic IP SIP Trunking arrangement. Since the date of the installation, the system has had erratic behaviour, DID numbers terminating incorrectly...
  3. ledfordb

    NEC Aspire and Xiox

    Does anyone have the correct settings to make the Xiox Prophet H-3 call accounting system work with the SMDR output from an NEC Aspire? Thank you in advance for your input!!!
  4. ledfordb

    I2004 sets fail after approximately 1 hour of no use

    Thank you team. I will investigate this further and see if I can isolate this failure. I will post with results or more confusion. Thanks again!
  5. ledfordb

    I2004 sets fail after approximately 1 hour of no use

    Just a wild shot here but I have read where all Nortel IP sets have an internal watchdog timer. The timer is defaulted at 200 seconds. It is reset by the TPS every 100 seconds and finally the display updates every 30 seconds. If the IP set fails to acknowledge these or any other messages within...
  6. ledfordb

    I2004 sets fail after approximately 1 hour of no use

    Thank you Ace, Is this the easiest fix for this timeout problem? Is it commonly programmed up in this manner? Thanks again!!!!
  7. ledfordb

    I2004 sets fail after approximately 1 hour of no use

    OK team, I try my best to only post unusual happenings. I need you guys input, so here goes. 1. Do Nortel VOIP phones support RSTP on the network? We have a flat network with no routing between the sites for this VLAN. 2. The VLAN that the VOIP phones is private to only the VOIP phones. We...
  8. ledfordb

    How can I route 911 & 9911 to internal extension?

    It's going pretty well, taking into account the database we were given. All in all, I believe we will survive......... So, tek....where might you be these days? B
  9. ledfordb

    How can I route 911 & 9911 to internal extension?

    Guys, I appreciate your top notch help on this. I actually have a couple of sites that are wanting this application. Not only will I drink a few ales in your honor but I will remove my hat as well. Thanks a million!!
  10. ledfordb

    How can I route 911 & 9911 to internal extension?

    I will test on my lab 11C before putting this in place. I will also cma by having a doc signed to release from any liability. I will raise my ale glass in your honor this evening! Many, many thanks!
  11. ledfordb

    How can I route 911 & 9911 to internal extension?

    If anyone can provide me with insight as to a method to accomplish the following, I would be most appreciative. Client needs to route 911 and 9911 calls to the security desk (internal extension). After the call is screened by security, local authorities will be notified by the security...
  12. ledfordb

    Wall mounts for bcm 50 psu?

    The correct part number is as follows; NT9T6700 Small System Wallmount Bracket WPP= $41.00 J. Baron Ledford LVCU Senior Project Engineer Nu-Vision Technologies LLC Georgia Offices
  13. ledfordb

    NAS M2250 console inop after 1 month of in service

    John, The console was in place and had been working for well over a month before the failure occured, that is what strikes me as strange. Just now we started the PEP installation and now it shows that file P18006D5 is corrupted and cannot be written to the directory on the PCMCIA drive. I have...
  14. ledfordb

    NAS M2250 console inop after 1 month of in service

    John, Thanks for the info, somehow I knew that you would be one of the first to reply. Here is the kicker, the console is and has been locked up entirely. It has not been in service since it initially locked up. I guess I could out and rebuild to see if that restores it to service. Some days...
  15. ledfordb

    NAS M2250 console inop after 1 month of in service

    OK, I read this site a great deal but have really never had the cause to post a question but here is my virgin plunge. I have a client with (2) Option 11C's that are networked across PRI-TIE circuits. About 2 months ago, I went to the locations and added an M2250 console on the far side of the...
  16. ledfordb

    Question

    The system is set by default to recall first to the station that camped/parked or placed call on hold. After a timer expires, it will by default recall to the attendant station where it will ring until answered if voicemail is not present. If voicemail is set up for the attendant, it will...
  17. ledfordb

    Message Delievery Delays

    Have you tried turning on trace diagnostics in the voicemail system startup string? Also, NTAC has numerous software patchs addressing the delayed message notification issues on certain software releases. What are the user mailbox message notification parameters set to, i.e., work phone/each...
  18. ledfordb

    looking for CoSessions

    Have you gotten Cosessions yet? Baron J. Baron Ledford LVCU Senior Field Engineer Nu-Vision Technologies LLC Georgia Offices
  19. ledfordb

    NEC - Electra Elite IPK question

    The Elitemail system uses some other type of audio format and to be honest, I can't remember it off of the top of my head. We seldom, if ever use an application such as you described. One quick fix that I can think of, if this message is time sensitive goes as follows; 1. Build a new mailbox...

Part and Inventory Search

Back
Top