Search results for query: *

I have an em200 that no matter what mm i put in it after initialization changes to unsupported module. Any ideas?

When I do a show faults or show modules it says its an insertion failure Also its just initializing and never does anything else

i'm currently doing a job and have run into an issue. I installed a used Em200 and adding the MM makes them show up as WRG/OOS MM.. I have tried swaping the cards and still get the same alarm. This leads me to believe it is something with the EM200. It is a case where some other type of...

it is a PRI, D-Channels are up

Recently users started reporting outgoing/incoming calls failing(fast busy)... When making an outbound call and doing a list trace tac i am getting a denial even 1195: Circ/channel unavail D1=0x3c D2=0x18022c problem is I can't seem to find any information on this specific denial event. 0x3c...

How do I clear the space on a PSU.. it's reading 100% Full.

new findings - so we did a busy, reset, release of the DS1 board and we now have it online for over 30 minutes, however 3 on the T1 channels are now ringing non-stop... with no one on the other end.

T1 is a CO Trunk setup auto/wink and have tried ground-start, everything worked just fine until we switched carriers. When we busy release the trunk group it comes up and we can make calls for 3-5 minutes before it goes out of service.. we have tried swaping cards, but the problem didn't follow...

AT&T says they see nothing wrong on their side.. we've swaped cards and verified that the same thing happens on a different card.

We switched carriers from Sprint to AT&T yesterday and every since our LOCAL T1 is out-of-service.. If we busy release the trunk it will work actively for 3-4 minutes and then go out of service again. I can make calls, etc fine during that time.. Any ideas?

much abliged kind sir!

Hi, is there a maximum size on flash media for backups?

IA770

update: There is no gateway, stand alone S8400, Intuity LX, Val Board So, it should be pretty straight forward right? Login to Voice mail, change IP, login to S8400 Change IP, move PBX to new VLAN reboot. ASA in with new IP address Change VAL board IP address and I should be good to go...

I have been asked to assist in a re-ip of a remote S8400, Intuity LX, there is a VAL board, and supposedly the documentation says there is a G450. However when I go to Media Gateways > Configuration is says No G350s, or G700s are currently available When I go to Server Configuration >...

Hi, I've setup SNMP Agents and Traps on my S8300's and its working great, however about 6 of my 50 or so Avaya PBX's are puking out Authentication Failure Traps coming from the Gateway. What keeps trying to Authenticate? And where?!

you should set the route pattern to DENY calls so it should be like this 15555555555 11 11 deny

or you could add the number to your ARS table.. which is probably much easier ;)

create a new COR and a new trunk group setup the new cor so it can only make local calls add users you don't want to have long distance access to that trunk group, set that trunk group to use your new COR.

S8300D / G450 / CM5.2.1 Should be good on the fixing issue. Thanks for your direction :)