Search results for query: *

I have a specific need for a system distribution list to contain only one network address at a time and I can't use a personal group list.

On the Octel 350 is there a limit to the number of type 6 mailboxes (System Distribution List) you can have ? I am assuming that in theory you could have thousands as long as you don't exceed the total mailbox limit of 30,000.

The Avaya support web site has some information.

Thanks for the information.

Had a problem with a 406V2 at 3.0.59. I eventually had to unplug the power supply and wait a few minutes to correct. What is the RTC not intialised error? Here is the output of the System Monitor: 39994mS PRN: RTC not initialised or reading is incorrect , Initialise ... 42334mS PRN: RTC...

OK, octelvoice, I don't understand? I have only used a telnet server before.

I know that on my system (406V2 3.0.59 )I had to change the shortcode for 911 to have 911S1234567890 where the 1234567890 was my published local phone number. When I had just the telephone number in the shortcode as 911 I did a test call and the 911 operator informed me that they did not have...

Thanks Ken. There is no red light on the alarm panel, so I will assume everything is OK.

I was having a problem at bootup where one of the fans was dead, so the system would not boot up. I replaced the fan, but I noticed that when I go into System Maintenance I get this display Menu 13 - System Maintenance Review Current Alarm...

There was only 1 error in the status log. It was a CD error with offset 47 as 03. That is why I am assuming that the message drive is going bad. The drive configuration line had a D D D . . . T so it saw the 3 drives and the tape drive. After it booted up I did look at the drive status...

I had system drive 1 that had been taken out of service due to a failure. I had a spare 2GB drive so I was doing a drive replacement offline. When that procedure was done it rebooted and I got those messages. I am assuming that the message drive is flaky. It still appears to be working, but I...

I have an Octel 250 at release 2.0.5. While the system was booting up I got an error on the line for the SCSI Disk drive diagnostic. The information printed out was " *4D/1* *** Got Check condition while doing the check condition cmd the request 2000d to target I.D. 2 ". The next line was...